Yamaha EMX3000 Owner's Manual download pdf (Page 7)

Control panel

EMX3000—Owner’s Manual

■

Master control section

In this section, you can adjust the ﬁnal level of

the outputs.

MONI 1 (monitor 1) fader

The MONI 1 fader adjusts the ﬁnal level of the

signal sent from the MONITOR 1 bus to the

MONI 1 jack (input/output panel

). If the

Power amp select switch

is set to MONI 1-

MONO, using this fader enables you to adjust the

level of the signal sent from the SPEAKER L/

MONI1 1/2 jacks to the speakers.

MONI 2 (monitor 2) fader

The MONI 2 fader adjusts the ﬁnal level of the

signal output from the MONITOR 2 bus to the

MONI 2 jack (input/output panel

EFFECT fader

The EFFECT fader adjusts the ﬁnal level of the

signal output from the EFFECT bus to the

EFFECT jack (input/output panel

ST 1 (stereo 1) fader

The ST 1 fader adjusts the ﬁnal level of the signal

sent from the STEREO bus to the ST 1 jacks

(input/output panel

). If the Power amp select

switch

is set to ST1 L-ST1 R, this fader also

adjusts the level of the signal sent to the SPEAK-

ERS jacks (rear panel

MONO (monaural) fader

The MONO fader adjusts the ﬁnal level of the

monaural signal output from the STEREO bus to

the MONO jack (input/output panel

If the Power amp select switch

is set to

MONI 1-MONO, this fader also adjusts the level

of the signal sent from the SPEAKERS R/MONO

1/2 jacks to the speakers.

If the Power amp select switch

is set to MONO

(BRIDGE), this fader adjusts the level of the sig-

nal sent from the SPEAKERS BRIDGE jack to the

speaker.

AFL (after fader listen)

When this switch is on, the output signal that

passes through the corresponding fader is sent to

the C-R/PHONES jack (input/output panel

Use these switches when you wish to monitor a

particular output signal through the headphones.

■

Tape in section

In this section, you can adjust the input level of a

cassette deck or a CD player that is connected to

the TAPE jacks (input/output panel

5).

K ST (stereo) control

This knob adjusts the level of the signal sent from

the TAPE jacks to the STEREO bus.

L PFL (pre-fader listen) switch

When this switch is on, the signal input from the

TAPE jacks is routed at the point before the ST

control K to the C-R/PHONES jack (input/out-

put panel B).

Note: The setting of this fader does not affect

the level of the signal sent from the EFFECT

bus to the built-in effect.

Note: The setting of this fader does not affect

the signal output from the STEREO bus to the

ST 2 jacks.

E F G H I

AFLAFLAFLAFLAFL

MONOMONI 2MONI 1 ST 1EFFECT

TAPE IN

PFL

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Yamaha EMX3000 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Audio mixers Yamaha EMX3000