Yamaha EMX3000 Owner's Manual download pdf (Page 11)

Input/output panel 7

EMX3000—Owner’s Manual

3 Channel input jacks 9~12A

Channel input jacks 9~12B

These are the input jacks for channels 9/10~11/12

and are used to connect to the stereo output jacks

of electronic instruments, cassette decks, or CD

players.

Use the A/B switch (control panel 2) to select

phone jacks (A) or phono jacks (B). The nominal

input level –34 dB~+10 dB.

4 ST SUB 1 (stereo sub 1) jacks

ST SUB 2 (stereo sub 2) jacks

These phone jacks are used to connect stereo out-

puts of a sub mixer. The signal input here can be

routed to the MONITOR 1 bus, MONITOR 2

bus, and STEREO bus. The nominal input level is

+4 dB.

5 TAPE jacks

These are input jacks that allow the signal from

an external device, such as a cassette deck and CD

player, to be added to the STEREO bus. The

nominal input level is –10 dBV.

6 P.AMP IN (power amp input) jacks

These phone jacks are used to input line-level sig-

nals to the two-channel built-in power ampliﬁer.

Connect an external mixer output here. The

nominal input level is +4 dB.

7 REC (record) jacks

These phono jacks are used to connect to the

inputs of a recording device, such as a cassette

deck, to record the signal from the STEREO bus.

The nominal output level is –10 dBV.

8 ST 1 (stereo 1) jacks

ST 2 (stereo 2) jacks

These phone jacks output the line-level signals of

the STEREO bus. Connect an external mixer or

additional PA system to these jacks.

Use the ST 1 fader (control panel H) to adjust

the ﬁnal output level at the ST 1 jacks, and use

the ST 2 control (control panel [) to adjust the

ﬁnal output level at the ST 2 jacks. The nominal

output level is +4 dB.

9 MONI 1 (monitor 1) jack

MONI 2 (monitor 2) jack

These phone jacks output the line-level signals of

the MONITOR 1/2 buses. Connect stage-moni-

toring ampliﬁers or powered speakers here. Use

the MONI 1 fader (control panel E) and the

MONI 2 fader (control panel F) respectively to

adjust the ﬁnal level of the signals output from

these jacks. The nominal output level is +4 dB.

0 MONO (monaural) jack

This phone jack mixes the STEREO bus signals

and output a monaural signal. Connect an addi-

tional PA system here. Use the MONO fader

(control panel I) to adjust the ﬁnal level of the

signal output from this jack. THe nominal out-

put level is +4 dB.

A EFFECT jack

The input of an external effect unit such as a

delay or echo can be connected to this jack.

The signal adjusted by the EFFECT control of

each channel will be sent to the EFFECT bus, its

level adjusted by the EFFECT fader (control

panel G), and output from this jack.

The nominal output level is +4 dB.

B C-R/PHONES (control room/head-

phones) jack

This is a stereo phone type output jack, and is

used to monitor the channels selected by the PFL

switches on the front panel and the buses selected

by the AFL switches. Connect the headphones

here, or use a “Y” cable to connect to a monitor

system.

The nominal output is 3mW when headphones

are connected, and +4 dB when a line-level

device of a monitor system is connected.

C FOOT SW (foot switch) jack

A separately sold Yamaha FC5 foot switch can be

connected to this jack so you can use your foot to

switch the built-in digital effect on/off. The digi-

tal effect ON switch on the front panel must be

set to ON in order to use a foot switch.

Note: Use only the L phone (A) jacks to con-

nect a monaural device that has phone jacks.

Note: Use only the L jack to connect a monau-

ral output device.

Note: If you insert a plug into this jack, the cor-

responding channel of the power amplifier will

be isolated, and no signals will be sent from the

mixer section. Use the LEVEL control (control

panel U) to adjust the level of the signal input

to the power amplifier.

Note: The setting of the graphic equalizer or

LEVEL control on the control panel does not

affect the signals output from these jacks. Ad-

just the recording level on the recording device.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Yamaha EMX3000 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Audio mixers Yamaha EMX3000