Yamaha YSP-1100 Owner's Manual download pdf (Page 32)

AUTO SETUP (IntelliBeam)

30 En

The supplied optimizer microphone collects and analyzes the sound that this unit produces in your actual listening

environment. Follow the procedure below to connect the optimizer microphone to this unit and make sure that the

optimizer microphone is placed in a proper location and that there are no large obstacles between the optimizer

microphone and the walls in your listening room.

• After you have completed the AUTO SETUP procedure, be sure to disconnect the optimizer microphone.

• The optimizer microphone is sensitive to heat.

– Keep it away from direct sunlight.

– Do not place it on top of this unit.

• Do not connect the optimizer microphone to an extension cable as doing so may result in an inaccurate sound optimization.

• An error may occur during the AUTO SETUP procedure if the optimizer microphone is not properly placed in your listening room. To

avoid the possibility of an error:

– Do not place the optimizer microphone to the extreme right or left from the center of this unit.

– Do not place the optimizer microphone within 1.8 m (6.0 ft) from the front of this unit.

– Do not place the optimizer microphone more than 1 m (3.3 ft) upper or lower from the center height of this unit.

• Make sure that there are no obstacles between the optimizer microphone and the walls in your listening room as these objects obstruct

the path of sound beams. However, any objects that are in contact with the walls will be regarded as a protruding part of the walls.

• The best possible results are achieved if the optimizer microphone is placed at the same height as your ears would be when you are

seated in your listening position. However, if this is not possible, you can manually fine-tune the sound beam angle and balance the

sound beam output levels using MANUAL SETUP (see page 60) once the AUTO SETUP procedure is completed.

• If a subwoofer with adjustable volume and crossover/high cut frequency controls is connected to this unit, set the volume between 11

and 1 o’clock as viewed on a conventional clockface and set the crossover/high cut frequency to the maximum.

1 Press STANDBY/ON on the front panel or on

the remote control to turn off the power of

this unit.

2 Connect the supplied optimizer microphone

to the OPTIMIZER MIC jack on the side of this

unit.

3 Place the optimizer microphone on a flat

level surface more than 1.8 m (6.0 ft) from the

front of the unit and within 1 m (3.3 ft) upper

or lower from the center height of the unit

with the optimizer microphone head upward

at your normal listening position.

Be sure to place the optimizer microphone on an imaginary

center line drawn from this unit.

You may want to use the supplied cardboard microphone stand

to affix the optimizer microphone at the same height as your

ears would be when you are seated in your listening position.

Installing the optimizer microphone

Notes

VOLUME

MIN

MAX

MIN MAX

CROSSOVER

HIGH CUT

Subwoofer

STANDBY/ON

Front panel

Remote control

Side view

Optimizer microphone

Note

Optimizer

microphone

More than

1.8 m (6.0 ft)

Within 1 m (3.3 ft)

upper or lower

from the center

Cardboard

microphone stand

Sofa

1 ... 31 32 33 ... 562

Comments to this Manuals

No comments

Yamaha YSP-1100 Owner's Manual Page 32

Comments to this Manuals

Related products and manuals for Receiver Yamaha YSP-1100