Yamaha PDM5520 User Manual download pdf (Page 20)

➛

Off-timer

On-timer

OPERATING INSTRUCTIONS (continued)

Displaying MULTI PICTURE

Input Signal Screen Display

If the PINP button on the remote control is pressed

MULTI PICTURE will display.

Activating the P-in-P mode from the RGB input screen

Pressing the P

INP button once will display 2 pictures.

• This mode can be available from RGB1 (DVI-PC) and

RGB2 (RGB) input.

• The speaker icon can be shifted left and right by pressing the

and SELECT buttons; the audio of the video will be output from

the side on which the speaker icon is located.

• The sub-screen position can be

selected up and down by pressing

SELECT buttons.

• When the speaker icon appears on

the left of the subscreen, as in the

illustration at right, you can use the

AV1, AV2, AV3, or AV4 buttons to

select the subscreen input mode.

• Pressing the P

INP button or the

RETURN button will cancel the 2 pictures display.

• “Frequency Mode” in the Setup Menu should be set to Movie

when sub-screen is the component signal of 1080i/50 or 1080i/60.

AV1: Displays the VIDEO input signal of the sub-screen.

Activating the Split mode from the video input screen

Pressing the P

P button one time will display 2 pictures.

• The speaker icon can be shifted left

and right by pressing the and

SELECT buttons; the audio of the

video will be output from the side on

which the speaker icon is located.

• The same video input mode cannot

be selected for both screens at the

same time.

• Pressing the PINP button or the

RETURN button will cancel the 2 pictures display.

• When the Video input is set to RGB Video, this Split mode is not

possible.

• Refer to the table for 2 pictures (Split) mode.

2 pictures (Split)

NOTE

• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not

change to power save mode.

• Please be careful since image retention will occur if the plasma monitor is left in MULTI PICTURE display state for a long period of time.

The input signal status can be displayed on the screen

by pressing the RECALL button of the remote control or

the monitor.

• The display will go out in approximately 6 seconds.

(‡ : available)

Input terminal

PAL-N

NTSC-M , PAL-M

576i, 576p

480i, 480p

1080i/50

1080i/60

720p/60

STB

Component

PAL-N

‡

NTSC-M

PAL-M

‡

576i

576p

‡

480i

480p

‡

1080i/50

‡

1080i/60

‡

720p/60

‡

STB Component

AV1

~AV4

AV1

AV2

RGB1

RGB2

AV1~AV4 AV1, AV2 RGB1 RGB2

Main

Sub

AV1 AV2

RGB 1 RGB 2

AV3

MUTE

VOL

AV4

AUTO P

SIZE RECALL

ID ID SET

RECALL button

RETURN button

PINP button

RGB2

AV1

(Sub-

screen)

AV1 AV2

Main Sub

AV1

Composite

-- -- Min.

-- -- : -- --

OFF

Input mode

Signal mode

➛

013_PDM-5520_U_E 12/13/04, 9:23 AM18

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Comments to this Manuals

No comments

Yamaha PDM5520 User Manual Page 20

Comments to this Manuals

Related products and manuals for Plasma TVs Yamaha PDM5520