Yamaha A3000 Owner's Manual download pdf (Page 40)

Changes in UTILITY MODE

Chapter 2 Upgrade Reference

UTILITY - MIDI - MIDI → Smp [MIDI-to-Sample]

This is a new page. You access this page by selecting the UTILITY | MIDI function and

then moving to the last page.

You use this page to set up the “MIDI to sample” feature. These settings are effective

only if MIDI-to-sample operation is enabled within the PROGRAM/SAMPLE SELEC-

TION page.

Recall that MIDI-to-sample feature allows you to use MIDI note-on input to switch the

sample being edited.

• Knob 2 or 3 (LayerSelection) selects whether sequential cycling (as set by the upper

or lower setting at the PROGRAM/SAMPLE SELECTION page) is used on all pages

that support MIDI-to-sample operation. You can set the value as shown below. For

information about how layering works, refer to the explanation of the PROGRAM/

SAMPLE SELECTION page, above (→ 16).

atAllPages Layered cycling is supported at all pages. Repeated input of a

given note will cause the A3000 to cycle through the samples

(banks) assigned to this note.

atSelectionPage Layered cycling is used only when you are working at the PRO-

GRAM/SAMPLE SELECTION page. When working at other

pages, the A3000 will not cycle the sample selection in response

to repeated input of the same note.

• Knob 5 (NameView) selects whether the screen displays the sample (bank) name

each time a new sample (bank) is selected by MIDI input. Set to enable to show the

name, or to disable to suppress the display. If you select enable, the name will re-

main on screen for about 1 second following selection by MIDI input.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 49 50

No comments

Yamaha A3000 Owner's Manual Page 40