Yamaha YST-RSW300 Manual download pdf (Page 12)

10 En

CONNECTIONS

For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the

connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them. Make sure that the +

and – polarity markings of the speaker cables are observed and set correctly. If these cables are reversed, the sound will

be unnatural and lack bass.

Do not let the bare speaker wires touch each other, because this could damage the

subwoofer or the amplifier, or both of them.

■ Before connecting

Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

■ How to connect

1 Press and hold the terminal’s tab, as shown in the figure below.

2 Insert the bare wire.

3 Release your finger from the tab to allow it to lock securely on the cable’s wire end.

4 Test the firmness of the connection by pulling lightly on the cable at the terminal.

Do not insert the insulation coating into the hole. The sound may not be produced.

Connecting to the INPUT1/OUTPUT terminals of the subwoofer

Caution

Good No Good

10mm

(3/8”)

Black: negative (–)

Red: positive (+)

Note

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 127 128

No comments

Yamaha YST-RSW300 Manual Page 12