Yamaha YZFR6V(C) User Manual download pdf (Page 94)

PERIODIC MAINTENANCE AND MINOR REPAIR

6-44

NOTE:

● Be sure to insert the retainer on the

brake caliper bracket into the slot

in the swingarm.

● Make sure that there is enough

space between the brake pads be-

fore installing the wheel.

2. Install the drive chain onto the rear

sprocket.

3. Install the axle nut, and then lower

the rear wheel so that it is on the

ground.

4. Adjust the drive chain slack. (See

page 6-28.)

5. Tighten the axle nut to the speci-

fied torque.

6. Tighten the adjusting bolts in direc-

tion (b) to their specified torque.

7. Tighten the locknuts to their speci-

fied torque.

EAU25870

Troubleshooting

Although Yamaha motorcycles receive

a thorough inspection before shipment

from the factory, trouble may occur dur-

ing operation. Any problem in the fuel,

compression, or ignition systems, for

example, can cause poor starting and

loss of power.

The following troubleshooting charts

represent quick and easy procedures

for checking these vital systems your-

self. However, should your motorcycle

require any repair, take it to a Yamaha

dealer, whose skilled technicians have

the necessary tools, experience, and

know-how to service the motorcycle

properly.

Use only genuine Yamaha replace-

ment parts. Imitation parts may look like

Yamaha parts, but they are often inferi-

or, have a shorter service life and can

lead to expensive repair bills.

1. Retainer

2. Slot

Tightening torque:

Axle nut:

110 Nm (11.0 m·kgf, 80 ft·lbf)

Tightening torque:

Drive chain slack adjusting bolt:

2.0 Nm (0.2 m·kgf, 1.4 ft·lbf)

Tightening torque:

Locknut:

16 Nm (1.6 m·kgf, 11 ft·lbf)

U2C010E0.book Page 44 Wednesday, October 26, 2005 10:19 AM

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 115 116

Comments to this Manuals

No comments

Yamaha YZFR6V(C) User Manual Page 94

Comments to this Manuals

Related products and manuals for Motorcycles Yamaha YZFR6V(C)