Yamaha WR250XZ(C) Owner's Manual Page 87

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 86
PERIODIC MAINTENANCE AND ADJUSTMENT
7-42
7
8. Remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
EAU45191
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the left-hand side.
TIP
Make sure that the retainer on the
brake caliper bracket is inserted
into the slot in the swingarm.
Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
2. Install the drive chain onto the rear
sprocket.
3. Install the washer and the axle nut.
4. Lower the rear wheel so that it is
on the ground, and then put the
sidestand down.
5. Adjust the drive chain slack. (See
page 7-28.)
6. Tighten the axle nut to the speci-
fied torque.
1. Wheel axle
1
1. Brake caliper bracket
2. Retainer
3. Slot
1
2
3
Tightening torque:
Axle nut:
125 Nm (12.5 m·kgf, 90 ft·lbf)
U32C15E0.book Page 42 Tuesday, July 14, 2009 11:43 AM
Page view 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 111 112

Comments to this Manuals

No comments