Yamaha RX-300 Owner's Manual download pdf (Page 15)

English

B PHONES jack

When you listen with headphones,

connect the headphones to the

PHONES jack. You can listen to

the sound to be output from the

main speakers through headphones.

When listening with headphones

privately, set both the SPEAKERS A

and B switches to the OFF position

and switch off the digital sound field processor by pressing the

SUR/KARAOKE EFFECT button on the front panel or the

EFFECT ON/OFF key on the remote control transmitter.

C SPEAKERS switches

Set the switch A or B (or both A and B) for the main speaker system

(connected to this unit) you will use to the ON position. Set the switch

for the main speaker system you will not use to the OFF position.

D A/B/C/D/E button

Press this button to select a desired group (A–E) of preset stations.

E Preset station number selector buttons

Select a preset station number (1 to 8).

F Tone controls

These controls are effective only for the sound from the main

speakers.

BASS

Used to increase or decrease the low frequency response.

The 0 position produces flat response.

TREBLE

Used to increase or decrease the high frequency response.

The 0 position produces flat response.

G BALANCE control

Adjusts the balance of the output volume to the left and right

speakers to compensate for sound imbalance caused by

speaker location or listening room conditions.

H CENTER LEVEL control

Adjusts the sound output level of the center speaker.

I REAR LEVEL control

\Adjusts the sound output level of the rear speakers.

J FM/AM button

Press this button to switch the reception band to FM or AM.

K MEMORY (MAN’L/AUTO FM) button

When this button is pressed, the MEMORY indicator flashes for

about 5 seconds. During this period, select a desired preset

station number by pressing the corresponding preset station

number selector button to enter the displayed station into the

memory.

When this button is pressed and held for about 3 seconds, the

automatic preset tuning begins. (Refer to page 24 for details.)

L EDIT button

This button is used to exchange the places of two preset

stations with each other.

M TUNING DOWN/UP button

Used for tuning. Press the “UP” side to tune in to higher

frequencies, and press the “DOWN” side to tune in to lower

frequencies.

N TUNING MODE (AUTO/MAN’L MONO) button

Press this button to switch the tuning mode to automatic or

manual. To select the automatic tuning mode, press this button

so that “AUTO” lights up on the display. To select the manual

tuning mode, press this button so that “AUTO” goes off.

O VOCAL AID button

This button functions only when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is

turned off (so that “E. OFF” appears on the display).

Pressing this button so that “VOCAL AID” lights up on the

display turns this function on, and whenever this button is

pressed, one of three audio output modes is selected in turn.

When the “VOCAL CUT” mode is selected, while playing a

source, medium frequencies (vocals, etc.) of the source sound

are attenuated only when there is an input from the

microphone.

To cancel this function, press this button once or more until

“VOCAL AID” goes off from the display.

This button is useful for singing Karaoke using a normal audio

source with vocals or a multisound source for Karaoke use.

P KEY CONTROL button

This button functions only when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off.

Pressing this button changes key of the tune currently playing.

The current key level is shown on the display.

(Left side): Whenever this side is pressed, key of the

track becomes lower.

(Right side): Whenever this side is pressed, key of the

track becomes higher.

Q ONE TOUCH KARAOKE button

This button functions only when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is

turned off (so that “E. OFF” appears on the display).

Pressing this button so that “ONE TOUCH KARAOKE” lights

up on the display turns this function on, and whenever this

button is pressed, one of three audio output modes is selected

in turn. When the “VOCAL CUT” mode is selected, medium

frequencies (vocals, etc.) of the playing source sound are

attenuated.

To cancel this function, press this button once or more until

“ONE TOUCH KARAOKE” goes off from the display.

This button is useful for singing Karaoke using a normal audio

source with vocals or a multisound source for Karaoke use.

R MIC jacks

One or two microphones can be connected to these jacks.

These are available when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off.

S MIC LEVEL control

This control functions only when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off.

This control adjusts the level of sound signals input from the

microphone(s) connected to this unit’s MIC jacks.

T ECHO level control

This control functions only when a DSP program for Karaoke,

BALLAD, POPS, JAZZ or ROCK is selected, or the DSP is off.

This control adjusts the level of echo applied to sound signals

input from the microphone(s) connected to this unit’s MIC jacks.

PHONES

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Comments to this Manuals

No comments

Yamaha RX-300 Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Karaoke systems Yamaha RX-300