Yamaha E25B Owner's Manual download pdf (Page 59)

Maintenance

54

an area with good ventilation.

●

Wipe up any spilled fuel immediately.

●

Reassemble the fuel tank carefully. Im-

proper assembly can result in a fuel

leak, which could result in a fire or ex-

plosion hazard.

●

Dispose of old gasoline according to lo-

cal regulations.

1. Empty the fuel tank into an approved

container.

2. Pour a small amount of suitable solvent

into the tank. Install the cap and shake

the tank. Drain the solvent completely.

3. Remove the screws holding the fuel joint

assembly. Pull the assembly out of the

tank.

4. Clean the filter (located on the end of the

suction pipe) in a suitable cleaning sol-

vent. Allow the filter to dry.

5. Replace the gasket with a new one. Re-

install the fuel joint assembly and tighten

the screws firmly.

EMU29312

Inspecting and replacing anode(s)

Yamaha outboard motors are protected from

corrosion by sacrificial anodes. Inspect the

external anodes periodically. Remove scales

from the surfaces of the anodes. Consult a

Yamaha dealer for replacement of external

anodes.

CAUTION:

ECM00720

Do not paint anodes, as this would render

them ineffective.

NOTE:

Inspect ground leads attached to external

anodes on equipped models. Consult a

Yamaha dealer for inspection and replace-

ment of internal anodes attached to the pow-

er unit.

EMU29320

Checking battery (for electric start

models)

WARNING

EWM00330

Battery electrolytic fluid is dangerous; it

contains sulfuric acid and therefore is

poisonous and highly caustic.

Always follow these preventive mea-

sures:

●

Avoid bodily contact with electrolytic

fluid as it can cause severe burns or

permanent eye injury.

●

Wear protective eye gear when han-

dling or working near batteries.

Antidote (EXTERNAL):

●

SKIN - Flush with water.

●

EYES - Flush with water for 15 minutes

ZMU02324

ZMU02325

1 ... 58 59 60 ... 70

Comments to this Manuals

No comments