
Tyros5 Owner’s Manual 75
4
Songs – Recording Your Performances as MIDI Songs –
Using Markers in Loop Playback
In this section, we’ll explain loop playback by the example of looping between markers SP 1 and SP 2.
1 Press the [PLAY/PAUSE] button to start playback from the top
of the Song.
2 After passing the [SP 1] point, press the [LOOP] button to turn
the loop function on.
The Song plays back up to the [SP 2] point, then goes back to [SP 1] and loops
between the two points.
3 To turn the loop function off, press the [LOOP] button again.
When you turn it off, playback continues past the [SP 2] point.
1 Press the [CHANNEL ON/OFF] button a few times to call up the
CHANNEL ON/OFF (SONG) display.
2 Use the [1 ]–[8 ] button to turn each channel on or off.
If you want to play back only one particular channel (solo playback), press and
hold down one of the [1 ]–[8 ] buttons corresponding to the desired
channel. Only the selected channel is turned to on and others are off. To cancel
solo playback, press the same button again.
3 Press the [EXIT] button to close the CHANNEL ON/OFF display.
Top of
the song
[SP 1]
End of
the song
[SP 2] [SP 3] [SP 4]
Turning Each Channel of the Song On/Off
2
The Voice for each channel can be
changed from the VOL/VOICE page of
the MIXING CONSOLE display
(page 93).
NOTE
Comments to this Manuals