Yamaha MCS-1330 Owner's Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
22 En
TROUBLESHOOTING
General (continuous from previous page)
Disc
USB
Problem Cause Remedy
See
page
No sound or
distorted sound
The sampling rate of a MP3 or WMA file
may not be compatible with the CD player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
23
Not linked with the
receiver
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Connect the receiver and the CD player with the
system control cable firmly.
9
Problem Cause Remedy
See
page
Disc playback does
not start.
You may use a CD-R/RW that is not
finalized.
Finalize the CD-R/RW.
The disc label may not be facing up. Check that the disc label is facing up.
The disc may be defective. Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
MP3/WMA disc may not contain
sufficient music tracks to be played back.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
23
Problem Cause Remedy
See
page
"NO USB" appears in
the display.
The USB device is not connected. Connect playable USB device.
11
"OVER CURENT"
appears in the
display.
The connected USB device not playable
on this system.
The connected USB device diagonally.
Disconnect the USB device. Change input source
other than USB and select USB an input source
again. Then connect playable USB device again.
The USB device
cannot be
recognized.
Check that the USB device is connected
correctly.
Connect the USB device firmly.
11
"NOT SUPPORT"
appears in the
display.
The connected the USB device is not
supported on this system.
Connect a supported USB device.
11
Remote control
Problem Cause Remedy
See
page
The remote control
does not work nor
function properly.
The remote control may be operated
outside its operation range.
For information on the remote control operation
range, refer to “Using the remote control”.
8
The remote control sensor on this system
may be exposed to direct sunlight or
lightening (invented fluorescent lamps).
Change the lighting or orientation of this system.
8
The battery may be worn out. Replace the battery with new one.
8
There are obstacles between the sensor of
this system and the remote control.
Remove the obstacles.
8
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments