Yamaha DSP-AX1 Manual download pdf (Page 83)

81

English

A source cannot be recorded

by a tape deck or VCR

connected to this unit.

“CHECK SP WIRES!" appears

on the display.

There is noise from a nearby

TV or tuner.

The sound is degraded when

listening with the headphones

connected to the CD player or

cassette deck that are

connected to this unit.

“INPUT DATA ERROR”

appears on the display and no

sound is heard.

Make additional connections to the analog

jacks (see pages 16 through 19).

Make sure all speaker cables are

connected correctly.

Move this unit farther away from the affected

equipment.

Turn on the power to this unit.

Check the source, or turn off the source

equipment, then turn it on again.

The source unit is connected to this unit

using digital jacks only.

Speaker cables are short circuited.

This unit is too close to the affected

equipment.

The power to this unit is off.

A non-standard source is played back, or

the equipment playing back the source is

not operating correctly.

Problem

Possible Cause What to Do

The remote control does not

work.

The remote control does not

function properly.

The remote control

does not “learn” new functions.

(The TRANSMIT indicator does

not light up or flash.)

Continuous functions such as

volume are learned, but

operate only for a moment

before stopping.

Replace the batteries with new ones and

press RESET (see page 5).

Press RESET on the remote control (see

page 5).

The remote control will function within a

maximum range of 6 m (20 feet), no more

than 30 degrees off-axis from the front panel

(see page 5).

Change the position of this unit.

Press RESET on the remote control (see

page 5).

Replace the batteries (and press RESET on

the remote control) (see page 5).

Place the remote controls at the proper

distance (see page 58).

Learning is not possible.

Further learning is not possible without deleting

unnecessary new functions (see page 62).

Press RESET on the remote control (see

page 5).

Be sure to press and hold the function button

on the other remote control until TRANSMIT

begins flashing slowly.

The batteries are dead.

The internal microcomputer has “frozen”.

Wrong distance or angle.

Direct sunlight or lighting (such as an

inverter type of fluorescent lamp) is striking

the remote control sensor of this unit.

The internal microcomputer has “frozen”.

The batteries of this remote control and/or

the other remote control are too weak.

The distance between the two remote

controls is too far or near.

The signal coding or modulation of the

other remote control is not compatible with

this remote control.

Memory capacity is full.

The internal microcomputer has “frozen”.

The learning process is incomplete.

Problem

Possible Cause What to Do

Remote Control

Troubleshooting

1 ... 82 83 84 85 86 87 88

Comments to this Manuals

No comments