Yamaha DSP-AX1 Manual download pdf (Page 27)

English

On-Screen Displays (OSD)

You can display the operation information for this unit on a video monitor. If you display the SET MENU and DSP sound field program

parameter settings on a screen, it is much easier to see the available options and parameters than it is by reading this information on the front

panel display.

If a video source is being reproduced, the OSD is superimposed over the image.

If a video source is not being reproduced (or the power of the source equipment is off), the OSD is shown on a blue background.

OSD Modes

You can change the amount of information the OSD shows.

Full Display .............. This mode always shows the sound field program parameter settings on the

video monitor (see page 73).

Short Display ............ This mode briefly shows the same contents as the front panel display at the

bottom of the screen, then disappears.

Display Off ............... This mode briefly shows the “DISPLAY OFF” message at the bottom of the

screen, then disappears. Afterwards, no changes to operations appear on the

screen except those of the ON SCREEN.

Notes:

• When you choose the Full Display mode, INPUT SELECTOR, VOLUME and some

other types of operation information are displayed at the bottom of the screen in the

same format as the front panel display.

• The OSD signal is not output through the REC OUT Selector, and will not be recorded

with any video signal.

• The SET MENU, TEST DOLBY SUR and TEST DSP appear regardless of the OSD

mode.

Selecting the OSD Mode

When you turn on the power, the video monitor and front panel

display shows the level of the main volume for a few seconds and

then switches to show the current sound field program.

Press ON SCREEN on the remote control repeatedly to change the

display mode.

The OSD mode changes in the following order: Full Display, Short

Display, and Display Off.

Caution:

• If you choose a video input source that has equipment connected to both the S VIDEO

IN and composite VIDEO IN jacks, and both the S VIDEO OUT and composite

VIDEO OUT jacks are connected to a video monitor, the video signal is output to both

the S VIDEO OUT and VIDEO OUT jacks. However, the OSD is carried only on the

S-video signal. If no video signal is input, the OSD is carried on both the S-video and

composite video signals.

• If your video monitor is connected only to the COMPONENT VIDEO terminals of

this unit, the OSD is not shown. Make sure to connect your video monitor to the

COMPONENT VIDEO terminal and either VIDEO or S VIDEO terminals if you

would like to see the OSD.

• Playing back video software that has an anti-copy signal or video signals with a lot of

noise may produce unstable images.

■ PAL/NTSC Switch (For General and China Models)

This unit is designed for use with both the NTSC and PAL television formats. Set

this switch to the position compatible with your TV.

ON SCREEN

LEVEL

SLEEP TEST

PARAMETER

SET MENU

PAL

NTSC

Full Display

Short Display

ON SCREEN

1 ... 26 27 28 ... 88

Comments to this Manuals

No comments

Yamaha DSP-AX1 Manual Page 27

Comments to this Manuals

Related products and manuals for AV receivers Yamaha DSP-AX1