Yamaha TSR-7810 Owner's Manual download pdf (Page 21)

En 21

Connection diagram

Refer to the following diagram and connect the speakers to the unit.

When using only one surround back speaker, connect it to the SINGLE jack (L side).

Connecting speaker cables

Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and

the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent

confusion, connect the black wire to the negative and the other wire to the positive terminal.

Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable and twist

the bare wires of the cable firmly together.

Loosen the speaker terminal.

Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the

terminal.

Tighten the terminal.

Using a banana plug

(U.S.A., Canada, China, Australia, Taiwan, Brazil and General models only)

Tighten the speaker terminal.

Insert a banana plug into the end of the terminal.

Connecting the subwoofer

Use an audio pin cable to connect the subwoofer.

SURROUND CENTER

CLASS 2 WIRING CABLAGE CLASSE 2

FRONT

SINGLE

SURROUND BACK

ZONE2/BI-AMP

SPEAKERS

SUBWOOFER

F.PRESENCE/ZONE2

EXTRA SP1

EXTRA SP2

The unit (rear)

FRONT

+ (red)

- (black)

FRONT

Banana plug

CENTER

FRONT

Audio pin cable

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 148 149

No comments

Yamaha TSR-7810 Owner's Manual Page 21