Yamaha CZR10 Owner's Manual download pdf (Page 10)

10 CZR series Owner’s Manual

Switching Between Passive and Bi-amp Mode

The factory setting for CZR internal wiring is the Passive mode. However, you can change the setting to the Bi-amp

mode. When driving in the Bi-amp mode, you must use an external crossover processor and the output from a 2-

channel amplifier. By driving in the Bi-amp mode, protection can be set separately for the LF and HF, and precise set-

tings can be made for crossover frequency and time alignment between the LF and HF. This optimizes the perfor-

mance capacity of each unit and increases the limit capability.

1. Using a M5 Phillips head screwdriver, remove all fixing screws on the rear panel, and remove the rear panel.

2. Disconnect the input and output cable connectors from the [PASSIVE IN]/[PASSIVE OUT] connectors on the network base,

and connect them to [BI-AMP IN]/[BI-AMP OUT] connectors respectively.

3. Re-install the rear panel to the speaker, reversing the steps above. (The base shown below is of the CZR10.)

• When removing the screws, make sure not to push the screws strongly. This may cause the nuts inside the cabinet to fall off.

• If the rear panel cannot smoothly be removed, hook the notches using a flat-bladed screwdriver, and pull out.

After changing the mode, we recommend marking the appropriate blank on the rear panel list to indicate the current state.

NOTE

Screws (six total)

Notch

PASSIVE IN

PASSIVE OUT

BI-AMP

OUT

BI-AMP

PASSIVE IN

PASSIVE OUT

BI-AMP

OUT

BI-AMP

Passive Bi-amp

To speaker units

From [INPUT/PARALLEL] jack From [INPUT/PARALLEL] jack

To speaker units

NOTE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Yamaha CZR10 Owner's Manual Page 10