Yamaha DX200 Owner's Manual download pdf (Page 26)

Parameters /

DX200 Editor Main Window

Filter EG Parameters

The Filter EG parameters determine how the timbre of the pattern changes over

time. This lets you produce subtle or pronounced ﬁlter effects (such as wah, for

example).

You can also conveniently edit the Filter EG parameters from the EG window. To

make changes to this, click on the down arrow above the EG window, and select

the Filter EG. Then, click on one of the box "joints" and drag it to change the EG

settings. The current relevant Filter EG values appear at the cursor as you drag it.

• Filter EG Attack Time

Range: 0 ... 127

This determines the attack time of the Filter EG, which is the time it takes for the signal to

reach its maximum cutoff frequency level after a key is pressed (key on). Higher values

produce a longer Attack time. (See illustration below.)

• Filter EG Decay Time

Range: 0 ... 127

This determines the decay time of the Filter EG, which is the time it takes for the signal to

reach its sustain level from the maximum level while a key is held. Higher values produce

a longer Decay time. (See illustration below.)

• Filter EG Sustain Level

Range: 0 ... 127

This determines the level of sustain of the Filter EG, which is the ﬁxed level of the cutoff

frequency maintained as long as the key is held. Higher values increase the Sustain

level. (See illustration below.)

• Filter EG Release Time

Range: 0 ... 127

This determines the release time of the Filter EG, which is the time it takes for the ﬁlter to

reach its initial level after a key is released (key off). Higher values increase the Release

time. (See illustration below.)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 81 82

No comments

Yamaha DX200 Owner's Manual Page 26