Yamaha RX-A2080 Quick Start Guide download pdf (Page 11)

En 11

Connecting speakers/subwoofer

Positioning speakers

Use the diagram as a reference for positioning speakers.

1 / 2 Front speaker (L/R)

3 Center speaker

4 / 5 Surround speaker (L/R)

6 / 7 Surround back speaker (L/R)

E / R Front presence speaker (L/R)

9 Subwoofer

For 7.1.2-channel system

Up to two subwoofers can be connected.

When connecting 6-ohm speakers

Set the unit’s speaker impedance to “6 Ω MIN”. For details, see “Setting the

speaker impedance” under “Connecting speakers” in the Owner’s Manual.

Precautions for connecting speaker cables

• Be sure that the unit and subwoofer are turned off.

• Prepare speaker cables in a place away from the unit, to avoid accidentally

dropping wire strands into the unit's interior which could result in a short

circuit or malfunction of the unit.

• Improper connection of speaker cables could cause a short circuit resulting

in damage to, or malfunctioning of, the unit or speakers.

– Carefully remove approximately 10 mm

(3/8") of insulation from the speaker-

connection ends of the cables, and twist

the bare wires of each speaker cable

together firmly.

– Do not allow the bare wires of separate speaker

cables to come into contact with one another.

– Do not allow speaker cable bare wires to come into

contact with metal parts on the unit (rear panel and

screws).

If “Check SP Wires” is shown on the front display when the unit is turned on,

turn off the unit and be sure that speaker cables have not caused a short

circuit.

10° to 30° 10° to 30°

0.5 to 1 m

(1.6 to 3.3 ft)

0.5 to 1 m

(1.6 to 3.3 ft)

1.8 m

(5.9 ft)

1.8 m

(5.9 ft)

0.3 m (1 ft)

or more

10 mm

(3/8")

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 83 84

Comments to this Manuals

No comments

Yamaha RX-A2080 Quick Start Guide Page 11

Comments to this Manuals

Related products and manuals for Supplementary music equipment Yamaha RX-A2080