Yamaha NS-F500 Manual download pdf (Page 4)

4 En

Notes

• Be sure to have another person support it.

• Pay extra attention to avoid scratching the speaker’s surface.

• Be careful not to apply force to the side of the speaker,

otherwise the speaker may fall causing damage to the

speaker or personal injury.

• To avoid accidents resulting from tripping over loose

speaker cables, affix them to the floor.

• Placing this unit too close to a CRT TV set might impair

picture color or create a buzzing noise. In this case, move the

speakers away from the TV. This is not an issue with LCD

and plasma TVs.

• The legs feature an adjustment function that enables you to

fine-tune the speaker height. If the speaker rattles on the

floor, adjust the length of the legs by turning them. Do not

loosen the legs too much. Otherwise, they may come off.

■ Attaching the spikes

At the time of shipment, legs are attached to the speaker. When

you use the supplied spikes, please remove the legs first.

If you are setting up the speaker on a thick carpet, you can

replace the legs with the spikes to increase stability and

improve sound quality. Remove the legs by turning them,

then follow the steps below:

Notes

• Be sure to have another person support it.

• The tips of the spikes may scratch or damage the flooring.

Please be careful when positioning the speakers.

• The tips of the spikes are sharp. When you adjust the protruding

length of the spikes, be careful not to injure your fingers.

1. Lay the speaker on the floor.

Use a blanket or cushion to avoid scratches.

2. Screw each spike into a spike nut so that the nut will stay

near the tip of the spike.

3. Remove the legs and screw the spikes into the holes on

the bottom of the speaker.

Place the speaker in the desired location in an upright

position. If necessary, adjust the length of the spike to

match the depth of the carpet by repeating the above-

mentioned steps.

5. When the length adjustment is complete, firmly tighten

the spike nut to the base on the bottom of the speaker.

Before making connections, make sure that the amplifier is

switched off.

Leg

Loosen

(higher)

Tighten

(lower)

Spike

Spike nut

CONNECTING TO YOUR

AMPLIFIER

Standard connections

Note

Do not insert the insulation into the hole.

If the connections are faulty, you will hear no sound

from the speaker.

Insulation coating

Bare wire

Loosen

Tighten

Black (–)

Red (+)

Amplifier

or Receiver

Speakers

output

terminals

NS-F500 NS-F500

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments

Yamaha NS-F500 Manual Page 4

Comments to this Manuals

Related products and manuals for Soundbar speakers Yamaha NS-F500