Yamaha S03 Owner's Manual Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
59
Multi Mode
21. AC1VarCtl
(AC1 Variation Effect Control Depth)
This determines the degree to which the Assignable
Controller 1 controls the Variation Effect.
Settings: –64~+63
n This can be set only when Variation Connection (above)
is set to “INS.” When Variation Connection is set to
“SYS,” “***” appears in the display and the setting
cannot be changed.
n The particular parameter that can be controlled with the
Assignable Controller 1 is fixed for each of the Variation
effects. Refer to the separate Data List for details.
n For information on the AC1, refer to AC1 CC No (pages
66 and 92 ) in the Multi and Utility modes.
Part
(Settings for each Part)
The following is an explanation of the Part parameters
used to edit each Multi.
n Refer to the Function Tree chart (page 20) or the
Parameter Table (page 22).
Voice Selection (PAGE 1)
Part Mix (PAGES 2 to 5)
Part General (PAGES 6 to 9)
Part Tone (PAGES 10 to 14)
Part Controller (PAGES 15 to 21)
Part Effect (PAGES 22 to 24)
1. Voice Selection
You can assign a Voice to each Part. Use the [+] and [–]
buttons to select the Part, then select its Voice. The
display will vary as follows according to the Memory
selected.
n Specify the particular Voice Memory by pressing the
appropriate Memory button: PRESET, USER or GM/XG.
n To select a Drum Voice, simultaneously hold down the
[DRUM] button and press the appropriate Memory
button: [USER] or [GM/XG].
n The Voice can be set by using the same method as with
Category Search (page 35).
n For details about Categories, refer to the Category List on
page 71. For details about using Category Search, see
page 35.
PRESET
Settings: PR001 ~ PR128
AC1VarCtl
+00
KEYELEMPAR T
OCTAVE
PAG E
21
StPiano1
PR001
KEYELEMPAR T
OCTAVE
PAG E
1
Common Effect/Voice Selection
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 111 112

Comments to this Manuals

No comments