Yamaha S03 Owner's Manual Page 101

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 100
101
Appendix
Troubleshooting
The following table provides troubleshooting hints and page references for some common problems. Most problems
may be simply the result of incorrect settings. Before calling for professional service, refer to the troubleshooting
advice below to see if you can find and correct the cause of the problem.
In particular, when you have trouble getting sound out of the S03, check the points below as you try to pinpoint the
cause of the trouble.
1 Connect a set of headphones to check whether the S03 is properly producing sound. If you can hear the sound in the
headphones but not from your connected audio system, you can assume that the problem is in the cable connections to
the audio system.
2 If no sound can be heard through the headphones, try selecting different Voices or Multis to see whether the problem
persists or not. If selecting another Voice or Multi clears up the problem, you can assume that the settings of the
original Voice or Multi were at fault.
n When song data settings, such as volume or expression (page 96) cause a decrease in volume, selecting a different Voice or Multi
will restore the volume.
3 If the problem still persists even after changing the Voice or Multi, check the master volume setting of the S03. Increase
the volume with the VOLUME slider and, if a foot controller is connected, press it down to the maximum.
4 If still no sound is output after step 3 above, the problem may be in the global settings of the S03 (UTILITY/MIDI), the
settings of any connected MIDI device, and/or the connecting MIDI cable.
No sound.
Relevant Volume Settings
Is the volume set appropriately? (Pages 8 and 15)
With the S03, if a Foot Controller has been connected to the FOOT CONTROLLER jack and set up for volume/
expression control, has it been fully depressed? (Page 14)
Relevant Voice and Multi Settings
Have the Volume or Level parameters below been set appropriately?
Voice Element Edit “Level” (Page 73)
Voice Key Edit “Level” (Page 85)
Voice Common Edit “Total Vol” (Page 71)
Voice Common Edit “Total Lvl” (Page 71)
Multi Part Edit “Volume” (Page 60)
Multi Common Edit “Total Vol” (Page 56)
Are any of the Parts or Elements muted? (Pages 48 and 55)
Has the “Element Sw” been set to off? (Page 73)
Have the filters been set so that almost all the sound is muted? (Pages 63, 77, 86)
Have the effects parameters been set appropriately? (Pages 56, 67, 72)
Has the effect type been set to something other than “No Effect”? (Pages 56 and 57)
Have the Velocity Sensitivity parameters been set appropriately? (Pages 62 and 72)
Have the Note Limit (Part/Voice) and Velocity Limit parameters been set appropriately? (Pages 60 and 73)
If Note/Velocity Limit Low is set to a value above Note/Velocity Limit High, no sound is output.
Page view 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 111 112

Comments to this Manuals

No comments