Yamaha DME Designer Owner's Manual download pdf (Page 15)

Advanced Setup

DME Setup Manual 15

5 Make sure that the “Network Setup” dialog box settings are made as shown below, the

click the [OK] button.

n The default settings can be used for the group master.

6 Use the same procedure to set the slave (DME8o-C and DME64N in the example) settings

and IP address.

n The subnet mask is fixed at “255.255.255.0”.

n The host address can be set from 2 to 253 for the Master device, and from 3 to 253 for Slaves.

Always use a private address (192.168.0.2. through 192.168.255.253) unless it is absolutely necessary to use a global

address. Consult with the network administrator if it is necessary to use a global address.

n Although an error will be displayed on DME units at this time, it can be ignored. (This message is output due to group

settings not yet having been made.)

DME8o-C DME64N

Master/Slave Slave

IP Address 192.168.0.3 192.168.0.4

Master ID 192.168.0.2

Link Mode 100Base-TX

Master/Slave Master

IP Address 192.168.0.2

Master ID –

Link Mode 100Base-TX

Group master settings (DME4io-C in the example).

Slave settings (DME8o-C in the example). Slave settings (DME64N in the example).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Yamaha DME Designer Owner's Manual Page 15