3-3
PERIODIC INSPECTION AND ADJUSTMENT x
3
INSP
ADJ
1 Cable Wheel
2 Locknuts
3 Throttle Cable
REMOTE CONTROL UNIT
Throttle Cables
1. Remove:
• Airbox cover.
2. Set:
• Remote Control levers to Neutral posi-
tion.
3. Check:
• Throttle Cable Wheel 1 should contact
the idle screw and there should be free
play in the cable.
• If adjustment is necessary, loosen the
Locknuts 2 at the throttle body end
and turn the cable adjuster.
4. Tighten:
• Locknuts 2 when adjustment is com-
plete.
Adjust Throttle Lever Stops:
1. Remove:
• Four screws holding the remote con-
trol unit cover.
2. Set:
• Remote control levers forward to the
Forward Wide-Open-Throttle (W.O.T.)
position.
3. Check:
• Each throttle cable at the throttle
body assemblies so that the Cable
wheel has 0.001” (0.025mm) to
0.079” (2.0mm) clearance to the
Stop. If incorrect → Adjust.
4. Adjust:
• Cable-Wheel-to-Stop clearance with
the Forward Throttle Stop bolts on
the Remote Control unit.
Be careful not to over-adjust, as the throttle
bodies can be damaged.
Comments to this Manuals