Yamaha JOGR JOGRR CS50 Owner's Manual download pdf (Page 66)

cleaning products, solvent or thin-

ner, fuel (gasoline), rust removers

or inhibitors, brake fluid, antifreeze

or electrolyte.

G Do not use high-pressure was-

hers or steam-jet cleaners sin-

ce they cause water seepage

and deterioration in the follo-

wing areas: seals (of wheel and

swingarm bearings, fork and

brakes), electric components

(couplers, connectors, instru-

ments, switches and lights),

breather hoses and vents.

G For scooters equipped with a

windshield: Do not use strong

cleaners or hard sponges as

they will cause dulling or scrat-

ching. Some cleaning com-

pounds for plastic may leave

scratches on the windshield.

Test the product on a small hid-

den part of the windshield to

make sure that it does not lea-

ve any marks. If the windshield

is scratched, use a quality

plastic polishing compound

after washing.

After normal use

1. Remove dirt with warm water, a

mild detergent, and a soft, clean

sponge, and then rinse tho-

roughly with clean water. Use a

toothbrush or bottlebrush for

hard-to-reach areas. Stubborn

dirt and insects will come off

more easily if the area is covered

with a wet cloth for a few minutes

before cleaning.

After riding in the rain, near the sea or

on salt-sprayed roads

1. Since sea salt or salt sprayed on

the roads during winter are extre-

mely corrosive in combination

with water, carry out the following

steps after each ride in the rain,

near the sea or on salt-sprayed

roads.

TIP

Salt sprayed on roads in the winter

may remain well into spring.

1. Clean the scooter with cold water

and a mild detergent after the

engine has cooled down. NOTI-

CE: Do not use warm water

since it increases the corrosive

action of the salt. [ECA10791]

2. Apply a corrosion protection

spray on all metal, including

chrome- and nickel-plated, surfa-

ces to prevent corrosion.

After cleaning

1. Dry the scooter with a chamois or

an absorbing cloth.

2. Use a chrome polish to shine

chrome, aluminum and stainless-

steel parts, including the exhaust

system. (Even the thermally indu-

ced discoloring of stainless-steel

exhaust systems can be removed

through polishing.)

3. To prevent corrosion, it is recom-

mended to apply a corrosion pro-

tection spray on all metal, inclu-

ding chrome- and nickel-plated,

surfaces.

4. Use spray oil as a universal clea-

ner to remove any remaining dirt.

5. Touch up minor paint damage

caused by stones, etc.

6. Wax all painted surfaces.

7. Let the scooter dry completely

before storing or covering it.

SCOOTER CARE AND STORAGE

7-2

7

49D-F819D-E0:49D-F819D-E0.QXD 18/12/08 19:57 Página 66

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Comments to this Manuals

No comments