Yamaha RXV2092 User Manual Page 19
- Page / 88
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
15
English
C TONE BYPASS switch
When this switch is pressed inward (ON), the input signal does
not pass through the tone (BASS and TREBLE) control circuitry
so that it is unaffected by the tone control circuitry. Use this
switch to obtain pure sound and to check the tone control
setting. Press this switch to release it outward (OFF) to use the
tone control circuitry.
D BASS and TREBLE Controls
Adjust low and high frequency response respectively for the
main channels only.
E BALANCE Control
Adjusts the left and right output volume to the Main Speakers to
compensate for sound imbalance caused by speaker positions
or listening room conditions.
F Preset Station Number Selector Buttons
Select a preset station number (1 to 8).
G REC OUT Selector
Selects the source to be recorded to a tape deck or
VCR independently of the setting of the input selector buttons.
However, when set to the SOURCE position, the setting of the
input selector buttons decides the source to be recorded to a
tape deck or VCR.
H FM/AM Switch
Press this switch to switch the reception band to FM or AM.
I MEMORY (MAN’L/AUTO FM) Button
When this button is pressed, the MEMORY indicator flashes for
about 5 seconds. During this period, select a desired preset
station number by pressing the corresponding preset station
number selector button to enter the displayed station into the
memory.
When this button is pressed and held for about 3 seconds, the
automatic preset tuning begins. (Refer to page 52 for details.)
J TUNING DOWN/UP Button
Used for tuning. Press the “UP” side to tune in to higher
frequencies, and press the “DOWN” side to tune in to lower
frequencies.
K EDIT Button
This button is used to exchange the places of two preset
stations with each other.
L TUNING MODE (AUTO/MAN’L MONO) Switch
Press this switch to switch the tuning mode to automatic or
manual. To select the automatic tuning mode, press this switch
so that “AUTO TUNING” lights up on the display panel. To
select the manual tuning mode, press this switch so that “AUTO
TUNING” goes off.
M DELAY/C/R/F/SWFR Switch
Whenever pressed, selects the item of changing delay time,
center speaker output level, rear speaker output level, front
effect speaker output level and subwoofer output level in turn.
* Depending on a mode of this unit, the number of selections is
reduced. For example, when the built-in digital sound field
processor (including the Dolby Pro Logic Decoder or the
Dolby Digital (AC-3) Decoder) is off, only the item for
changing subwoofer output level can be selected.
N –/+ Button
Adjusts the level of item selected by pressing the
DELAY/C/R/F/SWFR switch. Moreover, performs setting
changes and adjustments for functions selected by pressing
the SET MENU switch.
O SET MENU Switch
Whenever pressed, selects functions in the SET MENU mode.
- Natural Sound AV Receiver 1
- SAFETY INSTRUCTIONS 2
- (for US customers only) 3
- Congratulations! 4
- PRECAUTIONS 5
- CONTENTS 6
- GETTING STARTED 7
- To open the door 8
- To close the door 8
- FEATURES 9
- Dolby Pro Logic Surround 10
- Dolby Digital (AC-3) 10
- CINEMA DSP 11
- TEST DSP 13
- EFFECT LEVEL 13
- FRONT 0dB 13
- SPEAKER SETUP 14
- 5 Speaker System 15
- 6 Speaker System 15
- 7 Speaker System 15
- 4 Speaker System 15
- Main speaker 16
- Front effect speaker 16
- Center speaker 16
- Rear speaker 16
- Subwoofer 16
- FRONT PANEL 17
- DISPLAY PANEL 20
- CONNECTIONS 22
- L REAR OUTPUT Jacks 25
- M MAIN SPEAKERS Terminals 25
- N IMPEDANCE SELECTOR Switch 25
- O SWITCHED AC OUTLET(S) 25
- REAR PANEL SWITCH AND CONTROL 26
- SETTINGS 26
- GENERAL INSTRUCTIONS FOR 26
- BASIC CONNECTIONS 27
- (General Model) 27
- LD (DVD) player 28
- TV/Satellite tuner 28
- RF demodulator 29
- (YAMAHA APD-1 etc.) 29
- LD player 29
- CONNECTING TO S VIDEO JACKS 30
- ANTENNA CONNECTIONS 31
- Loop antenna 32
- Antenna stand 32
- Optional outdoor FM antenna 33
- Optional outdoor AM antenna 33
- CONNECTING SPEAKER SYSTEMS 34
- Main speaker A Main speaker A 35
- Main speaker B Main speaker B 35
- Power amplifier 35
- This unit 35
- TO THIS UNIT 36
- Subwoofer system 37
- (General model) 38
- IMPEDANCE 38
- SELECTOR 38
- 4. CENTER SPEAKER 39
- 5. REAR SPEAKER 39
- 6. MAIN SPEAKER 39
- 7. LFE/BASS OUT 39
- METHOD OF CHANGING SELECTIONS 41
- ROOM 2 REMOTE CONTROL UNIT 43
- 5 POWER ON and OFF keys 44
- 7 Input selector keys 44
- SPEAKER BALANCE ADJUSTMENT 45
- Main Front 46
- MAIN FRONT 46
- Remote control 46
- TIME/LEVEL 47
- SET MENU 47
- DESCRIPTIONS OF THE FUNCTIONS 48
- GENERAL OPERATION 50
- RECORDING A SOURCE TO 52
- AUDIO/VIDEO TAPE (OR DUBBING 52
- FROM A TAPE TO ANOTHER) 52
- TUNING OPERATIONS 54
- PRESET TUNING 55
- AUTOMATIC PRESET TUNING 56
- EXCHANGING PRESET STATIONS 57
- PRO LOGIC 58
- CANCELING THE EFFECT SOUND 59
- Adjusting delay time 64
- SETTING THE SLEEP TIMER 65
- REMOTE CONTROL UNIT 66
- RESET button 67
- (When the lid is open) 68
- TRANSMIT 69
- LEARNCLEAR MACRO 69
- Empty keys (1, 2) 70
- Input selector keys 71
- OPERATION CONTROL keys 71
- Lid is closed 71
- OPERATION 72
- (Set the MACRO switch to 74
- “QUICK” or “SLOW”.) 74
- Preset macro keys 74
- MACRO switch 74
- LEARNING A NEW FUNCTION 77
- MAKING A NEW MACRO 79
- CLEARING LEARNED FUNCTIONS 80
- Flashes 81
- Flashes slowly 81
- TROUBLESHOOTING 82
- Remote control unit 83
- SPECIFICATIONS 85
- VIDEO SECTION 86
- FM SECTION 86
- AM SECTION 87
- AUDIO SECTION (TUNER) 87
Related products and manuals for Receivers and Amplifiers Yamaha RXV2092
(73 pages)
(17 pages)
(14 pages)Sangean RCR-4 (V1) Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Radio Sangean RCR-4 (V1).
Wir stellen 4 PDF-Handbücher Sangean RCR-4 (V1) zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comments to this Manuals