Yamaha RX-495RDS User Manual download pdf (Page 12)

CONNECTING SPEAKERS

Connect the SPEAKERS terminals to your speakers with wire

of the proper gauge, cut as short as possible. If the

connections are faulty, no sound will be heard from the

speakers. Make sure that the polarity of the speaker wires is

correct, that is, + and – markings are observed. If these wires

are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do

not let them touch the metal parts of this unit as this could

damage this unit and/or speakers.

How to Connect:

Red: positive (+)

Black: negative (–)

➀

Unscrew the knob.

➁

Insert the bare wire.

[Remove approx. 5mm

(1/4”) insulation from

the speaker wires.]

➂

Tighten the knob and

secure the wire.

Notes

●

One or two speaker systems can be connected to this unit.

If you connect only one speaker system, connect it to either

the SPEAKERS A or B terminals.

●

Use speakers with the specified impedance shown on the

rear of this unit.

ABOUT THE ACCESSORY TERMINALS

AC OUTLET(S) (SWITCHED)

(Europe and Singapore models) ...... 2 SWITCHED OUTLETS

(U.K. model) ........................................ 1 SWITCHED OUTLET

Use these to connect the power cords from your components

to this unit.

The power to the SWITCHED outlets is controlled by this unit’s

POWER switch or the provided remote control transmitter’s

POWER key. These outlets will supply power to any

component whenever this unit is turned on.

The maximum power (total power consumption of

components) that can be connected to the SWITCHED AC

OUTLET(S) is 100 watts.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to the GND

terminal will normally minimize hum, but in some cases better

results may be obtained with the ground wire disconnected.

Use one of the two GND terminals on the rear of this unit for

the connection.

ANT

GND

75Ω

UNBAL

GND

Turntable

Loosen Tighten

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Comments to this Manuals

No comments

Yamaha RX-495RDS User Manual Page 12

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Yamaha RX-495RDS