Yamaha RX-V659 Owner's Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 132
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
13
CONNECTIONS
PREPARATION
Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty,
no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be
unnatural and lack bass.
Before connecting the speakers, make sure that this unit is turned off (see page 31).
Do not let the bare speaker wires touch each other or do not let them touch any metal part of this
unit. This could damage this unit and/or speakers.
Use magnetically shielded speakers. If this type of speakers still creates the interference with the
monitor, place the speakers away from the monitor.
If you are to use 4 or 6 ohm speakers, be sure to set “SP IMP.” to “6MIN” before using this unit
(see page 30).
A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Connect the striped (grooved, etc.) cable to the “+” (red) terminals of this unit and your speaker. Connect the
plain cable to the “–” (black) terminals.
The low-frequency signals of other speakers set to “SML” (or “SMALL”) or to “NONE” in “SPEAKER SET” (see pages 86 and 87)
are directed to the speakers selected in “LFE/BASS OUT” (see page 88).
You can use the PRESENCE/ZONE2 terminals to connect the Zone 2 speakers (see page 105).
Connecting speakers
Notes
CAUTION
FRONT
A
B
PRESENCE/ZONE2
SPEAKERS
SURROUND
CENTER
SURROUND BACK
SUBWOOFER
PRE OUT
23
1
6 7 10
98
4 5
Subwoofer
Center
speaker
Front speakers (A)
Surround back
speakers
LeftRight
LeftRight
Surround speakers
Front
speakers
(B)
(U.S.A. model)
LeftRight
Presence speakers
LeftRight
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 131 132

Comments to this Manuals

No comments