Yamaha RX-V493RDS Owner's Manual download pdf (Page 13)

English

For connecting to the MAIN SPEAKERS terminals

Red: positive (+)

Black: negative (–)

➀

Unscrew the knob.

➁

Insert the bare wire.

[Remove approx. 5mm

(1/4”) insulation from

the speaker wires.]

➂

Tighten the knob and

secure the wire.

For connecting to the REAR and CENTER SPEAKERS

terminals

Red: positive (+)

Black: negative (–)

➀

Press the tab.

➁

Insert the bare wire.

[Remove approx. 5mm

(1/4”) insulation from

the speaker wires.]

➂

Release the tab and

secure the wire.

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are

faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –

markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or

speakers.

MAIN LEVEL switch

Normally set to “0 dB”. If desired, you can decrease the

output level at the MAIN SPEAKERS terminals by 10 dB by

setting this switch to “–10 dB”.

ANT

GND

75Ω

UNBAL.

GND

PHONO

TAPE

MAIN

LEVEL

10dB 0dB

➁

➂

➀

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Comments to this Manuals

No comments

Yamaha RX-V493RDS Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Receiver Yamaha RX-V493RDS