Yamaha TSX-B15D Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
14 En
Refer to the table below if the unit does not operate properly. If the problem you are experiencing is not listed
below, or if the instruction below does not help, press to enter standby mode, disconnect the power cable,
and contact the nearest authorized Yamaha dealer or service center.
y Resetting the unit
If this unit does not function properly, resetting this unit may solve the problem. To reset this unit, press and
hold for more than 5 seconds.
TROUBLESHOOTING
General
Problem Cause Solution
The speakers make no
sound.
The volume may be set to the minimum
level.
Adjust the volume level.
The source may be incorrect. Select the correct source.
The unit is setting the alarm. Set the alarm switch to ON or OFF to
complete the alarm setting.
Sound suddenly turns off.
Auto Standby function is enabled. Turn on the system and play the source again.
Deactivate the Auto Standby ( page 5).
Sound is cracked/
distorted or there is
abnormal noise.
Input source volume is excessive, or
volume of this unit is excessive.
Adjust the volume with VOLUME.
The unit does not operate
properly.
The unit may have received a strong
electrical shock such as lightning or
excessive static electricity, or power
supply may have dropped.
Press to enter standby mode and
disconnect the power cable. Wait about
30 seconds, reconnect the power cable, and
turn on the system.
The system turns on but
immediately shuts off.
The power cable may be connected
improperly.
Make sure the power cable is plugged into the
wall outlet firmly.
The unit may have received a strong
electrical shock such as lightning or
excessive static electricity.
Disconnect the power cable. Wait about
30 seconds, reconnect the power cable, and
turn on the system.
A digital or high-frequency
equipment produces
noises.
The unit may be placed too close to the
digital or high-frequency equipment.
Place the unit farther away from the
equipment.
The clock setting has been
cleared.
The unit is left more than one week after
you disconnect the power cable from the
wall outlet.
Plug the power cable into the wall outlet
firmly, and set the clock again ( page 4).
The clock flashes.
The unit is setting the clock. Press to cancel setting the clock.
The unit is setting the alarm. The alarm
switch on the rear panel is set to SET.
Set the alarm switch on the rear panel to ON
or OFF to complete the setting.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 147 148

Comments to this Manuals

No comments