# shutdown -i6 -g0 -y
5. When the system comes back up, you can log in and check the installation as shown in the section Checking
Update Pack 1 Installation.
If you later decide that you want to add additional packages from the Update Pack CD, see the section
Installing Additional Packages after the Update Pack Set.
Checking Update Pack Installation
Once installed, use the following command to confirm that the uw713up1 set has completely installed. The
system should respond with output similar to that shown in the example below:
# pkginfo -lc set uw713up1
PKGINST: uw713up1
NAME: UnixWare 7, Release 7.1.3 Update Pack 1
CATEGORY: set
ARCH: IA32
VERSION: 7.1.3
VENDOR: Caldera International, Inc.
PSTAMP: UnixWare 7.1.3 02/16/2003 bl1
INSTDATE: Feb 17 2003 09:33 AM
STATUS: completely installed
If the STATUS field indicates anything other than completely installed, there was some problem during
installation of the set. Re-install the set and record any error messages displayed. Then, check the Late News and
Support web sites to check for additional Update Pack 1 notes.
A similar command can be used to check the status of any individual packages installed, as in this example:
# pkginfo -l nd nics
Package information can also be obtained using the SCOadmin Application Installer, launched either from the
graphical desktop, or from the command line as shown:
# scoadmin application &
Installing Additional Packages after the Update Pack Set
After you have installed the Update Pack 1 Set (uw713up1) and rebooted your system, you can use either the
Upgrade Wizard or the pkgadd(1M) command to install any packages on the CD-ROM that you did not select
when you installed the Set. Use one of these methods:
Use the Upgrade Wizard:
Follow the Installation Procedure, omitting Step 3.
NOTE: Using the Upgrade Wizard will re-install the Update Set (uw713up1) automatically before installing additional packages. If you
want to load additional packages without re-installing the Update Set, use pkgadd, as shown below.
Use the pkgadd command:
Follow Steps 1 and 2 of the Installation Procedure, and then enter the following:
# pkgadd -d device package...
The device is cdrom1 if you followed Step 2a; or, /install if you followed Step 2b. Replace package with the
names of one or more packages on the CD (see CD Contents). This example installs the nd and nics
packages from a mounted ISO image file:
# pkgadd -d /install nd nics
5 of 15
UnixWare 7.1.3 Update Pack 1 New Features and Notes
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals