Yamaha CLP-220 User Manual download pdf (Page 35)

CLP-220 Keyboard Stand Assembly

ENGLISH

3. Mount A.

CAUTION

• Fingers can become pinched between the main

unit and the rear or side panels, be extra careful

so as not to drop the main unit.

• Do not hold the keyboard in any position other

than the position shown in the illustration.

3-1 Assemble the side panel protection (card-

board) pad, as shown in the illustration.

Then, remove the two backing papers from

the adhesive tape on the protection pad.

3-2 Cover the top of D and E with the side panel

protection pad. Then, ﬁx the protection pad

with the adhesive tape.

3-3 Lower A horizontally while aligning a pin on

the inner side of D and E with a bracket in

the slot on the left and right side of A, then

attach A to D and E securely.

3-4 Remove the side panel protection pad.

4. Secure A.

4-1 Secure A by tightening the short screws 2

(6 × 16mm) from the front.

5. Secure B and C.

5-1 Securely tighten the screws on the top of B

that were attached in Step 2-2.

5-2 Securely tighten the screws on C that were

attached in Step 1-3.

6. Connect the pedal cord.

6-1 Insert the pedal cord plug to the pedal con-

nector from the rear.

6-2 Attach the cord holders to the rear panel as

shown, then clip the cord into the holders.

6-3 Use a vinyl tie to take up any slack in the

pedal cord.

3-3

3-2

Place your hands

at least 10 cm

from either end

of A when

positioning it.

4-1

5-1

5-2

PEDAL

6-1

6-3

6-2

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 49 50

Comments to this Manuals

No comments

Yamaha CLP-220 User Manual Page 35

Comments to this Manuals

Related products and manuals for Musical Instruments Yamaha CLP-220