Yamaha YST-SW515 Owner's Manual download pdf (Page 10)

CONNECTIONS

For connection, keep the speaker cables as short as

possible. Do not bundle or roll up the excess part of the

cables. If the connections are faulty, no sound will be heard

from the subwoofer or the speakers, or both of them. Make

sure that the + and – polarity markings of the speaker

cables are observed and set correctly. If these cables are

reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other, because

this could damage the subwoofer or the amplifier, or both of

them.

■ Before connecting

Remove the insulation coating at the extremity of each

speaker cable by twisting the coating off.

■ How to connect:

1 Loosen the terminal’s knob, as shown in the figure.

2 Insert the bare wire.

3 Tighten the knob.

4 Test the firmness of the connection by pulling lightly

on the cable at the terminal.

U.S.A., Canada and Australia models only

Banana Plug conection are also possible.

1 Tighten the terminal knob.

2 Simply insert the banana plug into the terminal

After all connections are completed, plug in the subwoofer

and other audio/video components to the AC outlet.

Connecting to the INPUT1/OUTPUT

terminals of the subwoofer

Good No Good

10mm

(3/8”)

Red: positive (+)

Black: negative (–)

Plug in the subwoofer to the AC outlet

To AC outlet

YST-SW515_G.book Page 8 Thursday, August 19, 2004 10:49 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 120 121

No comments

Yamaha YST-SW515 Owner's Manual Page 10