Yamaha ROADLINER XV19SC Instruction Manual Page 1

Browse online or download Instruction Manual for Motorcycles Yamaha ROADLINER XV19SC. Yamaha ROADLINER XV19SC Instruction manual User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
INSTALLATION INSTRUCTIONS
YAMAHA
TOOLS NEEDED
- #1 Phillips Screwdriver
- 5 mm Allen Wrench
- 10 mm Socket Wrench
- Less than 1 hour
Yamaha Roadliner / Stratoliner
Fuel Injected Models
INTRODUCTION: Congratulations on your purchase of the Fuelpak
Fuel Management System for fuel injected Yamaha Roadliner / Stratoliner
motorcycles. Please take the time to read the entire instruction manual
before attempting to install. DO NOT adjust the Fuelpak until you have
thoroughly read the instruction manual and the unit is fully installed. If
you have questions, please call (562) 921-0071.
SUMMARY: To achieve the optimum performance from your
application, it is recommended that you install a high performance
air filter in conjunction with this unit. The Fuelpak will be installed
in-line the factory injector wiring harness and the throttle position sensor. The
Fuelpak will be tucked under the seat next to the ECU with the cables routing
to the right side of the engine.
1. Be sure the main switch is in the off position during
the installation process. Failure to do this will cause
the “check engine” light to be set.
2. Remove seat exposing the Electronic Control Unit
(ECU) and battery.
3. Remove the right side coil cover by removing two
allen screws and gently pulling.
4. Disconnect the 6 pin factory connector behind the
ignition coils. (Fig 1)
5. Connect Fuelpak 6 pin connectors in-line with factory
connectors.
6. Disconnect 3 pin factory connectors behind the
ignition coils and connect Fuelpak 3 pin connectors
in-line with factory connectors.
7. Route Fuelpak harness up to battery area and reinstall
coil side cover.
8. Connect Fuelpak black wire to negative ground
wire. (Fig 2)
9. Locate factory 2 pin connector with brown and black
wires. Disconnect empty connector and attach
Fuelpak red wire connector.
10. Connect Fuelpak 10 pin connector to Fuelpak
harness.
11. You are now ready to set-up your Fuelpak.
INSTALLATION INSTRUCTIONS FOR P/N 65001
READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION
FUEL INJECTION MANAGEMENT SYSTEM
ROADLINER / STRATOLINER
NOTICE:
Fuelpak is intended for racing or off-highway
use only, and is not legal for sale or use in
California on pollution-controlled vehicles.
PLEASE NOTE: FUELPAK USE REQUIRES A HIGH PERFORMANCE AIR FILTER.
Page view 0
1 2

Summary of Contents

Page 1 - ROADLINER / STRATOLINER

INSTALLATION INSTRUCTIONSYAMAHATOOLS NEEDED - #1 Phillips Screwdriver - 5 mm Allen Wrench - 10 mm Socket Wrench - Less than 1 hourYamaha Roadliner /

Page 2 - WARRANTY INFORMATION

HOW IT WORKSENTERING VALUES1. Remove Fuelpak clear case cover by removing all four screws, save hardware.2. Turn on main power with key, but do no

Comments to this Manuals

No comments