Yamaha DT125X Owner's Manual download pdf (Page 39)

1. Start the engine, warm it up for

several minutes, and then turn it

off.

2. Place an oil pan under the trans-

mission to collect the used oil.

3. Remove the oil filler cap and

drain bolt to drain the oil from the

transmission.

4. Install the transmission oil drain

bolt, and then tighten it to the

specified torque.

Tightening torque:

Transmission oil drain bolt:

15 Nm (1,5 m•kgf)

5. Add the specified amount of the

recommended transmission oil,

and then install and tighten the oil

filler cap.

Recommended transmission oil:

See page 8-1.

Oil change quantity:

0,8 L (0,85 US qt)

ECA10450

CAUTION

● In order to prevent clutch slip-

page (since the transmission

oil also lubricates the clutch),

do not mix any chemical additi-

ves with the oil.

● Make sure that no foreign

material enters the transmis-

sion.

6. Start the engine, and then let it

idle for several minutes while

checking the transmission for oil

leakage. If oil is leaking, imme-

diately turn off the engine and

check for the cause.

EAU20070

Coolant

The coolant level should be checked

before each ride. In addition, the coo-

lant must be changed at the intervals

specified in the periodic maintenance

and lubrication chart.

EAU20170

To check the coolant level

1. Place the vehicle on a level surfa-

ce and hold it in an upright posi-

tion.

NOTE:

● The coolant level must be chec-

ked on a cold engine since the

level varies with engine tempera-

ture.

● Make sure that the vehicle is

positioned straight up when

checking the coolant level. A

slight tilt to the side can result in

a false reading.

2. Remove panel D. (See page 6-6.)

3. Check the coolant level in the

coolant reservoir.

FULL

LOW

6

PERIODIC MAINTENANCE AND MINOR REPAIR

6-8

1D0-F8199-E2.qxd 20/9/04 11:32 Página 39

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 73 74

Comments to this Manuals

No comments