Yamaha 2010 Raider Owner's Manual download pdf (Page 53)

PERIODIC MAINTENANCE AND ADJUSTMENT

7-12

7

12. Pour only 2.5 L (2.6 US qt,

2.2 Imp.qt) of the specified amount

of recommended engine oil

through the filler hole, insert the

dipstick, and then tighten the oil fill-

er cap.

13. Start the engine, rev it several

times, and then turn it off.

14. Remove the engine oil filler cap,

and then gradually fill the oil tank

with the remaining oil quantity

while regularly checking the oil lev-

el on the dipstick.

TIP

Be sure to wipe off spilled oil on any

parts after the engine and exhaust sys-

tem have cooled down.

NOTICE

ECA15080

● In order to prevent clutch slip-

page (since the engine oil also

lubricates the clutch), do not

mix any chemical additives. Do

not use oils with a diesel speci-

fication of “CD” or oils of a high-

er quality than specified. In

addition, do not use oils labeled

“ENERGY CONSERVING II” or

higher.

● Make sure that no foreign mate-

rial enters the oil tank.

15. Install the engine oil filler cap.

16. Start the engine, and then let it idle

for several minutes while checking

it for oil leakage. If oil is leaking, im-

mediately turn the engine off and

check for the cause.

17. Turn the engine off, and then

check the oil level and correct it if

necessary.

18. Install the rider seat.

EAU20051

Transfer case oil

The transfer case must be checked for

oil leakage before each ride. If any

leakage is found, have a Yamaha deal-

er check and repair the vehicle. In addi-

tion, the transfer case oil level should

be checked and the oil must be

changed by a Yamaha dealer at the in-

tervals specified in the periodic mainte-

nance and lubrication chart.

Recommended engine oil:

See page 9-1.

Oil quantity:

Without oil filter cartridge replace-

ment:

4.10 L (4.33 US qt, 3.61 Imp.qt)

With oil filter cartridge replacement:

4.90 L (5.18 US qt, 4.31 Imp.qt)

U29S12E0.book Page 12 Monday, June 1, 2009 1:05 PM

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 93 94

Comments to this Manuals

No comments