Yamaha MX-800 User's Guide download pdf (Page 56)

2-24

Chapter 2: BIOS information

2.5.1 Power Up Control

Even if installed, your screen saver does not display when you select [Blank

Screen] for the above field.

[V/H SYNC+Blank] blanks the screen and turns off vertical and horizontal

scanning. Configuration options: [Blank Screen] [V/H SYNC+Blank] [DPMS

Standby] [DPMS Suspend] [DPMS OFF] [DPMS Reduce ON]

HDD Power Down [Disabled]

Shuts down any IDE hard disk drives in the system after a period of inactivity as

set in this user-configurable field. This feature does not affect SCSI hard drives.

Configuration options: [Disabled] [1 Min] [2 Min] [3 Min]...[15 Min]

ACPI Suspend To RAM [Disabled]

This field allows you to enable or disable the ACPI Suspend-to-RAM feature. To

support this feature, the +5VSB of the power supply should have the capacity to

provide more than 720mA current. Configuration options: [Disabled] [Enabled]

Suspend Mode [Disabled]

Sets the time period before the system goes into suspend mode. Configuration

options: [Disabled] [1~2 Min] [2~3 Min] [4~5 min] [8~9 Min] [20 Min] [30 Min]

PWR Button < 4 Secs [Soft Off]

When set to [Soft off], the ATX switch can be used as a normal system power-off

button when pressed for less than 4 seconds. [Suspend] allows the button to have

a dual function where pressing less than 4 seconds puts the system in sleep mode.

Regardless of the setting, holding the ATX switch for more than 4 seconds powers

off the system. Configuration options: [Soft off] [Suspend]

AC PWR Loss Restart [Disabled]

This allows you to set whether or not to reboot the system after power

interruptions. [Disabled] leaves your system off while [Enabled] reboots the

system. [Previous State] sets the system back to the state it was before the power

interruption. Configuration options: [Disabled] [Enabled] [Previous State]

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63 64

No comments

Yamaha MX-800 User's Guide Page 56