Yamaha NS-P60 Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
PRECAUTIONS
This model is designed to be used as an effect speak-
er system.
Read these precautions carefully before using your speak-
ers.
Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speakers may be damaged.
When using an amplifier with a rated output power high-
er than the nominal input power of the speakers, care
should be taken never to exceed the speakers’ maximum
input.
Do not attempt to clean the speakers with chemical sol-
vents as this might damage the finish. To clean, wipe
with a dry, soft cloth.
To prevent the enclosure from warping or discoloring, do
not place the speakers where they will be exposed to
direct sunlight or excessive humidity.
Do not place the speakers where they are liable to be
knocked over or struck by falling objects. Stable place-
ment will also ensure better sound performance.
Placing the speakers on the same shelf or rack as the
turntable can result in feedback.
As these speakers contain strong magnets, avoid plac-
ing watches, magnetic tapes, etc. near them. Also, plac-
ing the speakers near a TV set may impair picture color.
If this happens, move the TV set away from the speak-
ers.
Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speak-
ers.
Mounting the speakers on a wall
The speakers can be mounted on a wall by using the
holes provided on the speakers’ back panels.
Make sure that the screws are caught by a narrow part of
the holes securely.
Put the screws into a wall according to the figure shown
below.
Fasten screws into a firm wall or wall support as shown in
the figure below, and hang the holes on the protruding
screws.
WARNING
Each speaker weights 2.2 kg (4 lbs. 13 oz.). Do not
mount them on thin plywood or soft wall surface materi-
al, as the screws may come out of the flimsy surface,
causing the speakers to fall down and be damaged, or
result in personal injury.
Do not fasten the speakers to wall with nails, adhesives,
or other unsound hardware. Long term use and vibra-
tions may cause them to fall down.
To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
NS-E55
Natural Sound Effect Speaker System
SETTING UP THE SPEAKERS
Pads
Holes
Diam. 4 – 5 mm
40 mm
Min.
12mm
2mm
Tapping screw
(Available at a
hardware store)
Wall or
wall support
Page view 2
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments