Yamaha NS-P60 Manual download pdf (Page 2)

BEFORE MAKING CONNECTIONS, MAKE SURE THAT

THE AMPLIFIER IS SWITCHED OFF.

■ CONNECTIONS

● Connect the screw-type input terminals at the rear of the

speaker to the speaker output terminals of your amplifier

with the provided speaker cords.

● One side of the speaker cord is red and the other side is

black. Connect the (+) terminals on both the amplifier

and the speaker using this red side. Connect the (–) ter-

minals on both components using the black side of the

cord.

● Be careful not to reverse the polarity (+, –). If connected

with reversed polarity, the sound will be unnatural and

lack bass.

Procedures:

➀ Loosen the terminal knob.

➁ Insert the bare speaker wire end properly into the ter-

minal hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cord.]

➂ Tighten the knob.

➃ Test the security of the connection by pulling lightly the

cord at the terminal.

Note

Do not let the bare speaker wires touch each other as

this could damage the speaker or

the amplifier, or both of them.

SPECIFICATIONS

Type..........................2-way 3-speaker acoustic-suspension

speaker system

Magnetic-shielding type

Speaker Unit....................................10 cm cone woofer x 2

2.2 cm dome tweeter

Input Terminal.....................................................Screw-type

Impedance .................................................................6 ohm

Frequency Response ..................................70 Hz – 30 kHz

Nominal Input Power.....................................................60W

Maximum Input Power ................................................180W

Sensitivity (2.83V, 1m) ................................................91 dB

Crossover Frequency..................................................5 kHz

Dimensions (WxHxD).......................465 x 135 x 173.5 mm

(18-5/16” x 5-5/16” x 6-7/8”)

Weight .................................................3.5 kg (7 lbs. 12 oz.)

Accessories ......................................Speaker cord (4m) x 1

Velcro strip x 2

* Specifications subject to change without notice due to

product improvements.

* Care should be taken not to exceed the input power val-

ues noted above.

CONNECTION TO YOUR AMPLIFIER

Center speaker

output terminals

of the amplifier

NS-C55

Tighten

Red (+)

Black (–)

Red

Loosen

Amplifier

V415010

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Yamaha NS-P60 Manual Page 2

Comments to this Manuals

Related products and manuals for Loudspeakers Yamaha NS-P60