Yamaha 115D Owner's Manual download pdf (Page 23)

Basic components

18

NOTE:

After the main switch is first turned on, all

segments of the display come on as a test.

After a few seconds, the gauge will change

to normal operation. Watch the gauge when

turning on the main switch to make sure all

segments come on.

NOTE:

The speedometer displays km/h, mph, or

knots, according to operator preference. Se-

lect the desired unit of measurement by set-

ting the selector switch on the back of the

gauge. See the illustration for settings.

EMU26610

Trim meter

This gauge shows the trim angle of your out-

board motor.

NOTE:

Memorize the trim angles that work best for

your boat under different conditions. Adjust

the trim angle to the desired setting with the

power trim and tilt switch.

EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-

board motor.

NOTE:

●

Memorize the trim angles that work best

for your boat under different conditions.

Adjust the trim angle to the desired using

the power trim and tilt switch.

●

If the trim angle of your motor exceeds the

trim operating range, the top segment on

the trim meter display will blink.

1. Speedometer

2. Fuel gauge

3. Trip meter/clock/voltmeter

4. Warning indicator(s)

1. Cap

2. Selector switch (for speed unit)

3. Selector switch (for fuel sensor)

ZMU04581

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 80 81

Comments to this Manuals

No comments