Yamaha RX-V383 Quick Start Guide download pdf (Page 12)

12 En

1 Turn on the subwoofer and set the volume to half.

If the crossover frequency is adjustable, set it to maximum.

2 Place the YPAO microphone at your listening

position and connect it to the YPAO MIC jack on

the front panel.

The screen below appears on the TV.

Note

Place the YPAO microphone at your listening position (same height as your ears).

We recommend the use of a tripod as a microphone stand. You can use the tripod

screws to stabilize the microphone.

3 Press ENTER.

The measurement will start in 10 seconds.

It takes about 3 minutes to measure.

The screen below appears on the TV when the measurement finishes.

Note

If an error message (such as E-1) or warning message (such as W-2) appears,

see “Error messages” or “Warning messages” under “Optimizing the speaker

settings automatically (YPAO)” in the Owner’s Manual.

4 Confirm the results displayed on the screen and

press ENTER.

5 Use the cursor keys (e/r) to select “SAVE” (Save)

and press ENTER.

6 Disconnect the YPAO microphone from the unit.

This completes optimization of the speaker settings.

VOLUME

CROSSOVER/

HIGH CUT

MIN MAX

Auto Setup

Start

Exit

Auto Setup

Measurement Finished

Result

3/2/0.1ch

3.0/10.5m

-3.0/+10.0dB

OK : ENTER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

No comments

Yamaha RX-V383 Quick Start Guide Page 12