Yamaha DVD-S510 Owner's Manual download pdf (Page 15)

Connecting the power cord

After completing all connections, connect the AC power cord to an AC

power outlet

Note: When the player is in the “STANDBY” mode, it is still consuming some power.

If you wish to disconnect your player completely from the power, unplug the power

cord from the AC outlet.

Caution: Only qualified service personnel should remove the cover

or attempt to service this device.

Remote control battery installation

Loading the batteries

1 Open the battery compartment cover.

2 Insert batteries as indicated inside the battery compartment.

3 Close the cover.

Caution: Do not mix old and new batteries. Never mix

different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match the video

signal of your TV. This setting only affects the television’s on-screen display

that shows the stop and setup modes. You may select either NTSC or PAL. To

change the DVD player setting to PAL or NTSC, follow the steps below.

1 Unplug the DVD player from the mains.

2 Press and hold 9 and

/T on the front of the DVD player. While

holding 9 and

/T plug in the mains.

3 After PAL or NTSC appears on the display panel of the DVD player,

release 9 and

/T at the same time. The PAL or NTSC that appears

on the display panel indicates the current setting.

4 To change the setting, press

/T within three seconds. The new

setting (PAL or NTSC) will appear on the display panel.

PREPARATION

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 222 223

No comments

Yamaha DVD-S510 Owner's Manual Page 15