Yamaha Tyros4 Owner's Manual download pdf (Page 109)

Tyros4 Owner’s Manual 109

Installing the Optional Flash Memory Expansion Module

3 Remove the four screws from the cover.

4 Insert the module into the socket by fol-

lowing the procedure below.

4-1

Insert the module vertically in the socket and

position the screws (of the module) to the

female screws respectively.

4-2 Press the top of the connector as shown, then

push the connector firmly into the socket.

4-3 Tighten each screw of the module to each

female screw of the Tyros4 with your hand as

shown.

5 Re-install the cover you removed in step

3, in reverse order.

6 Check that the installed module is func-

tioning properly.

6-1

Set the Tyros4 right-side up, and then turn the

power on.

6-2 Call up the Format operation display.

[VOICE CREATOR]  [E] EXPANSION

MODULE

6-3 Execute the Format operation following the

messages on the display.

If the module has been installed properly, the appro-

priate available memory size is indicated in the

PROPERTY display.

([VOICE CREATOR]  [E] EXPANSION MOD-

ULE  [7 ]–[8 ] PROPERTY)

Removing Flash Memory Expansion

Module

1 Loosen both the screws with your hand

as shown below.

2 Pull the module vertically out of the

socket.

3 Attach the cover to the bottom panel.

Keep the removed screws in a safe place. They will be used when reattaching the

cover to the instrument after installation.

(Rear side)

NOTE

Flash Memory

Expansion Module

Connector

Female screw

Socket

Female screw

(Rear side)

4-3

4-2

• If you cannot loosen the screws with your hand, use a Phillips

screwdriver. In this case, be careful NOT to scratch the module or

the Tyros4.

• Be careful NOT to drop the screws inside the instrument when loos-

ening them.

NOTICE

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 125 126

Comments to this Manuals

No comments

Yamaha Tyros4 Owner's Manual Page 109

Comments to this Manuals

Related products and manuals for Digital pianos Yamaha Tyros4