Yamaha CDR-HD1300 Owner's Manual Page 93

  • Download
  • Add to my manuals
  • Print
  • Page
    / 105
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 92
E-87
English
APPENDIX
To change the display brightness
(Dimmer Setup)
You can change the brightness of the display.
1. Press MENU while this unit is in the stop mode.
The display changes for the menu item selection.
2. Select “Sys. Utility” by rotating the MULTI JOG knob
(pressing +/– on the remote control).
3. Press the MULTI JOG knob (ENTER on the remote
control).
The display changes for the system utility item selection.
4. Select “Dimmer Setup” by rotating the MULTI JOG
knob (pressing +/– on the remote control).
5. The current setting is indicated on the display if the
MULTI JOG knob (ENTER on the remote control) is
pressed.
The selection and the brightness change in 3 levels as the
MULTI JOG knob is rotated (+/ on the remote control is
pressed).
Note
Initial setting is “Dimmer Bright”.
6. Press the MULTI JOG knob (ENTER on the remote
control) or COMPLETE.
The display brightness has been set.
7. Press a to exit.
The display changes to the one when this unit was in the stop
mode.
Dimmer Setup
L
R
dB –30 –10 –6 –2 0
Dimmer Bright
L
R
dB 30 10 6 20
Dimmer Bright
L
R
dB 30 10 6 20
Dimmer Mid
L
R
dB 30 10 6 20
Dimmer Dark
L
R
dB 30 10 6 20
SYSTEM UTILITY
To set the video output (VIDEO Output)
You can switch the on-screen display output through the VIDEO
OUT jacks on and off.
1. Press MENU while this unit is in the stop mode.
The display changes for the menu item selection.
2. Select “Sys. Utility” by rotating the MULTI JOG knob
(pressing +/– on the remote control).
3. Press the MULTI JOG knob (ENTER on the remote
control).
The display changes for the system utility item selection.
4. Select “VIDEO Output” by rotating the MULTI JOG
knob (pressing +/– on the remote control).
5. The current setting is indicated on the display if the
MULTI JOG knob (ENTER on the remote control) is
pressed.
Switch “VIDEO On” and “VIDEO Off” by rotating the MULTI
JOG knob (pressing +/– on the remote control).
Note
Initial setting is “VIDEO On”.
6. Press the MULTI JOG knob (ENTER on the remote
control) or COMPLETE.
The on-screen display output is set to on or off.
Note
If “VIDEO Off” is selected, the video circuit inside this unit is
also turned off. You can enjoy the playback or recording in higher
quality sound.
7. Press a to exit.
The display changes to the one when this unit was in the stop
mode.
VIDEO Output
L
R
dB 30 10 6 20
VIDEO On
L
R
dB 30 10 6 20
110_HD1300(E)84-94 02.12.17, 4:49 PM87
Page view 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 104 105

Comments to this Manuals

No comments