Yamaha CD-S2000 Service Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 59
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
23
CD-S2000
CD-S2000
モジュール基板への書き込みWriting to the Module Board
モジュール基板をサービス部品に交換した場合、最新の
ファームウェアの書き込みを行ってください。
必要なツール
ファームウェアCD
ファームウェアCDは、PCへ最新のファームウェ
アを指定のダウンロード先からダウンロードして
制作してください。
ファームウェア:S5JAxxx6.BIN
操作方法
注意 ファームウェアの書き込み中に電源を切らな
いでください。
1. 電源コードをACコンセントに接続します。
2. 本機の“POWER ON/OFF”スイッチをONにしま
す。(Fig. 7)
3. 本機の“OPEN/CLOSE”キーを押し、トレイを開
きます。(Fig. 7)
After replacing the Module board with the replacement part,
be sure to write the latest firmware.
Required Tools
Firmware CD
* To make the firmware CD, download the latest firm-
ware from the specified download source to PC.
Firmware: S5JAxxx6.BIN
Operation Procedures
CAUTION: Do not turn off the power while updat-
ing the firmware.
1. Connect the power cable to the AC outlet.
2. Set the POWER ON/OFF switch of this unit to
the ON position. (Fig. 7)
3. Press the OPEN/CLOSE key of this unit to open
the tray. (Fig. 7)
"POWER ON/OFF" switch
“POWER ON/OFF”スイッチ
"OPEN/CLOSE" key
“OPEN/CLOSE”キー
"PLAY" key
“PLAY”キー
Fig. 7
4. ファームウェアCDをトレーに載せ、トレーを閉じ
ます。
すると、“UPGRADE?”が表示されます
4. Put the firmware CD on the tray and close the
tray.
Then UPGRADE? is displayed.
UPGRADE?UPGRADE?
UPGRADE?UPGRADE?
UPGRADE?
5. 本機の“PLAY”キーを押し、書き込みを開始し
す。
すると、“UPGRADE”が点滅します。
5. Press the PLAY key of this unit, and then writing
of the firmware is started and UPGRADE flashes.
Flashing / 点滅
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 58 59

Comments to this Manuals

No comments