22
CD-S2000
CD-S2000
※ 表示されたファームウェアのバージョンが、書き
込んだファームウェアのバージョンと異なる場
合、“マイコンへの書き込み”の1から15までをも
う一度実施してください。
* When the displayed firmware version is different
from written firmware version, follow the steps from
1 to 15 of “Writing to the microprocessor” again.
12. 本機の“POWER ON/OFF”スイッチをOFFにします。
13. 本機の電源コードをACコンセントから抜きます。
14.“FlashSta.exe”を終了します。
15. RS232Cクロスケーブル、RS232C変換アダプター
カード電線を取り外します。
・ ファームウェアバージョンの確認
テストモードでファームウェアが正しく更新されたこ
とを確認します。
テストモードの詳細は「テストモード」を参照してくだ
さい。
1. 本機の電源コードをACコンセントに接続します。
2. 本機の“PLAY”キーと“STOP”キーを押しながら、
“POWER ON/OFF”スイッチをONにします。(Fig. 6)
テストモードが起動します。
3. マイコンのファームウェアバージョンの表示を選択し
ます。
表示されたファームウェアのバージョンが書き込んだ
ファームウェアのバージョンと同じであることを確認
します。
12. Set the “POWER ON/OFF” switch of this unit to the
OFF position.
13. Disconnect the power cable of this unit from the AC
outlet.
14. End “FlashSta. exe.”
15. Disconnect the RS232C cross cable, RS232C conver-
sion jig and flexible flat cable.
• Confirmation of firmware version
Confirm the firmware is updated successfully from the
test mode.
For more information, refer to “TEST MODE”.
1. Reconnect the power cable of this unit to the AC outlet.
2. While pressing the “PLAY” and “STOP” keys of this
unit, set the “POWER ON/OFF” switch to the ON posi-
tion. Then the Test mode is activated. (Fig. 6)
3. Select the function to display the firmware version of
the microprocessor. Check that the displayed firmware
version is the same as the written firmware version.
Key of this unit / 本体キー
Set the “POWER ON/OFF” switch to the
ON position while pressing these keys.
これらのキーを同時に押しながら、
“POWER ON/OFF”スイッチをONにします。
X0012X0012
X0012X0012
X0012
071001071001
071001071001
071001
The firmware version /
ファームウェアバージョン
The updating data / 更新日付
"PLAY" key
“PLAY”キー
"STOP" key
“STOP”キー
"POWER ON/OFF" switch
“POWER ON/OFF”スイッチ
Fig. 6
Comments to this Manuals