Yamaha R-N500 Owner's Manual download pdf (Page 13)

11 En

Connections

PREPARATION

■ Setting the speaker impedance

Under its default settings, the unit is configured for 8-ohm

speakers. When connecting 4 to 6-ohm speakers, set the

speaker impedance to “4  MIN”.

1 Before connecting speakers, connect the

power cable to an AC wall outlet.

2 While holding down RETURN on the front

panel, press A (power).

3 Check that “SP IMP.” is displayed on the

front display.

4 Press SELECT/ENTER to select “4  MIN”.

Press

(power) to set the unit to turn off and

remove the power cable from the AC wall outlet.

You are now ready to connect the speakers.

■ Connecting speaker cables

Speaker cables have two wires. One is for connecting the

negative (-) terminal of the unit and the speaker, and the

other is for the positive (+) terminal. If the wires are

colored to prevent confusion, connect the black wire to the

negative and the other wire to the positive terminal.

Remove approximately 10 mm (3/8”) of insulation from the ends of

the speaker cable and twist the bare wires of the cable firmly together.

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side (upper

right or bottom left) of the terminal.

d Tighten the terminal.

■ Connecting via banana plug

(Australia model only)

Tighten the knob and then insert the banana plug into the

end of the corresponding terminal.

■ Bi-wire connection

Bi-wire connection separates the woofer from the

combined midrange and tweeter section. A bi-wire

compatible speaker has four binding post terminals. These

two sets of terminals allow the speaker to be split into two

independent sections. With these connections, the mid and

high frequency drivers are connected to one set of terminals

and the low frequency driver to another set of terminals.

Connect the other speaker to the other set of terminals in

the same way.

When making bi-wire connections, remove the shorting bridges

or cables on the speaker.

To use the bi-wire connections, press SPEAKERS A and

SPEAKERS B on the front panel or on the remote control so that

both SP A and B light up on the front display.

Connecting the speakers

A (power)

SELECT/ENTER

RETURN

SPIMP.8MIN

10 mm

(3/8")

Note

Banana plug

This unit

Speaker

SPEAKERS A/B

SPEAKERS

A/B

SOURCE

RECEIVER

CODE SET

SLEEP

DIMMER

SPEAKERS

A B

COAX1

COAX2

OPT1

OPT2

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Comments to this Manuals

No comments

Yamaha R-N500 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Car media receivers Yamaha R-N500