Yamaha YHT-392 Owner's Manual download pdf (Page 21)

19 En

Optimizing the speaker setting for your listening room (YPAO)

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

4 To select a sound character for adjustment,

press nCursor k to select “EQ” and then

press nCursor l / h.

If this unit does not work when you press nCursor,

press lSETUP once and then operate this unit.

This unit has a parametric equalizer that adjusts the

output levels for each frequency range. The equalizer

is adjusted to produce a cohesive sound field based on

automatically measured speaker characteristics.

In “EQ,” you can select the following parametric

equalizer characteristics suitable for the desired

sound characteristics.

Natural

This adjusts all speakers to achieve natural sound.

Select this if sounds in the high frequency range seem

too strong when “EQ” is set to “Flat.”

Flat

This adjusts each speaker to obtain the same

characteristics. Select this if your speakers have

similar qualities.

Front

This adjusts each speaker to obtain the same

characteristics as the front left and right speakers.

Select this if your front left and right speakers have

significantly better qualities than the other speakers.

5 Press nCursor n to select “Start” and then

press nENTER to start the setup procedure.

A countdown starts and a measurement starts in 10

seconds. A loud test tone is output during

measurement.

Notes

• During the automatic setup procedure, do not perform any

operation on this unit.

• Press nCursor k to cancel the automatic setup procedure.

When measurement is successfully completed,

“YPAO Complete” appears on the front panel display.

Notes

• When “E-xx” (xx indicates the number) appears during Auto

Setup, it means that measurement is canceled due to an error. For

details, see “When an error message is displayed during

measurement” (page 20).

• When an error occurs during measurement, “W-xx” (xx indicates

the number) appears. For details, see “When a warning message is

displayed after measurement” (page 20).

6 Press nENTER to confirm the settings.

The speaker characteristics are adjusted according to

measurement results.

7 To cancel the operation, press nCursor l /

h to select “Cancel” and press nENTER.

When “Disconnect MIC” appears, remove the

optimizer microphone. Auto Setup is complete.

• If you do not want to apply the measurement results, select “Cancel.”

• Perform “Auto Setup” again if you change the number or positions of

speakers.

• If you press nENTER before removing the optimizer microphone,

“1 Auto Setup” of “Speaker Setup” in the setup menu (see page 39) is

displayed.

Measurement takes about 3 minutes. To obtain precise

results, stay where you will not disturb the

measurement, such as to the side of or behind the

speakers or outside the room.

EQ;;;;;Natural

YPAOComplete

The optimizer microphone is sensitive to heat. Store it

in a cool place and away from direct sunlight after

measurement. Do not leave it in a place where it will be

subjected to high temperatures such on an AV

component.

>SetCancel

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 87 88

Comments to this Manuals

No comments

Yamaha YHT-392 Owner's Manual Page 21

Comments to this Manuals

Related products and manuals for AV receivers Yamaha YHT-392