SETUP
Extended functionality that can be configured as needed (Advanced Setup menu)
En 100
Avoiding crossing remote control
signals when using multiple
Yamaha receivers
The remote control of the unit can only receive signals
from a receiver which has an identical ID (remote
control ID). When using multiple Yamaha AV receivers,
you can set each remote control with a unique remote
control ID for its corresponding receiver.
On the contrary, if you are setting the same remote
control ID for all receivers, you can use one remote
control to operate 2 receivers.
Resetting the SIRIUS Satellite
Radio™ parental lock code
Reset the SIRIUS Satellite Radio parental lock code to
the factory default setting.
m
Numeric keys
oCODE SET
qSOURCE/RECEIVER
7856
90
1234
SOURCE
CODE SET
RECEIVER
ENE
OLUME
ENHAN
E
R. DE
DE
TRAI
HT
LEEP
RE DIRE
T
VI
I
V
TV
RADI
ENTER
1
EC
EN
MEN
P-
DI
PLAY
ZONE 2
PTI
N
ON SCREE
NF
EMORY
RE
ET
DI
3
5
-A
D
K
LT
5
A
SIRIU
TUN.
ATE
R
o
q
m
ID1 (Default) Receives the remote control signals set in
ID1.
ID2 Receives the remote control signals set in
ID2.
ID1 is set for both remote control and receiver by
default. To avoid crossing remote control, change the
remote control ID for both remote control and
receiver.
REMOTEID-ID1
■ To change the remote control ID
1
Press oCODE SET using a pointed
object such as the tip of a ballpoint pen.
2
Press qSOURCE/RECEIVER.
3
Enter the desired remote control ID code.
To switch to ID1:
Enter “5019” using
mNumeric keys.
To switch to ID2:
Enter “5020” using
mNumeric keys.
Once the remote control code is registered successfully
qSOURCE/RECEIVER will blink twice.
Perform each of the following steps within
1 minute. Settings will be automatically stopped if
more than 1 minute passes since the last operation.
To reset, repeat from step 1.
SOURCE
RECEIVER
4
ZONE
DE
E
Registration successful: blinks twice
Registration failed: blinks 6 times
• If setup fails, repeat from step 1.
• Returns to ID1 after the remote control code is
initialized (☞
p. 98).
RESET Resets the code to the factory default
setting.
CANCEL (Default) Cancels resetting of the parental lock
code.
SRPIN-CANCEL
Comments to this Manuals