Yamaha RX-V465 Owner's Manual download pdf (Page 49)

45 En

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

In the advanced setup, you can set basic operations of this

unit, such as on and off of a bi-amp connection, or

initialize user settings. Perform the following steps to

change settings.

1 Set this unit to the standby mode.

2 Press ASTANDBY/ON while pressing and

holding LSTRAIGHT on the front panel.

The advanced setup menu appears on the front panel

display.

3 Press KPROGRAM l / h repeatedly to

select the parameter you want to change.

The default setting are marked with “*.”

• XXX in the following parameters indicate the set values.

SP IMP. - XXX

Selects output impedance of this unit according to

connected speakers.

REMOTE ID-XXX

Sets a remote control ID. When using multiple

Yamaha AV receivers, you can operate them with a

single remote control by setting the receiver IDs to

the same setting.

INIT-XXXXXXXXX

Initializes various settings stored in this unit. You can

select an initialization method from the following.

DSP PARAM: All parameters of sound field

programs

ALL: Reset this unit to initial factory

settings

CANCEL: Cancellation of initialization

4 Press LSTRAIGHT a few times to select the

value you want to change.

The value selected here becomes effective when this

unit is turned on the next time. You can change

multiple settings by repeating steps 3 and 4.

5 Press ASTANDBY/ON, turns off this

system, and press ASTANDBY/ON again.

The value set in step 3 becomes effective, and this

unit turns on. When you select initialization in step 3,

the initialization is performed.

Two IDs are provided for the remote control of this unit. If

another Yamaha amplifier is in the same room, setting a

different remote control ID to this unit prevents unwanted

operation of the other amplifier.

ID1 is set for both remote control and amplifier by default.

When you change the remote control ID, display

“Advance Setup” (see the previous section) and change the

ID for the amplifier too.

1 Press cCODE SET on the remote control

using a pointed object such as the tip of a

ballpoint pen.

bTRANSMIT blinks twice.

2 Press lSETUP on the remote control.

3 Enter the desired remote control ID code.

To switch to ID1:

Enter “5019” using sNumeric keys.

To switch to ID2:

Enter “5020” using sNumeric keys.

Once the remote control code is registered,

bTRANSMIT blinks twice.

If it fails, bTRANSMIT blinks six times. Repeat

from step 1.

• Initializing the remote control code (see page 44) returns it to ID1.

Advanced setup

Choices: 6 MIN/8 MIN*

Choices: ID1*/ID2

Choices: DSP PARAM/ALL/CANCEL

ADVANCEDSETUP

Setting a remote control ID

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 73 74

Comments to this Manuals

No comments

Yamaha RX-V465 Owner's Manual Page 49

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V465