Yamaha RX-V463 Owner's Manual download pdf (Page 29)

25 En

Optimizing the speaker setting for your listening room

English

PREPARATION

4 Make sure that “SETUP” is set to “AUTO”

and the pointer is pointing at “START”.

You can also select the following setup methods. In this

case, press

k to select “SETUP”, press

l / h to

select the one of the following choices and then select

“START”.

Choices: AUTO, RELOAD, UNDO, DEFAULT

• Select “AUTO” to automatically run the entire

“AUTO SETUP” procedure.

• Select “RELOAD” to reload the last “AUTO

SETUP” settings and override the previous

settings.

• Select “UNDO” to undo the last “AUTO SETUP”

settings and restore the previous settings.

• Select “DEFAULT” to reset the “AUTO SETUP”

parameters to the initial factory settings.

“RELOAD” or “UNDO” is available only when you have

previously run “AUTO SETUP” and confirmed the results.

5 Press

n to select “START” and then press

ENTER to start the setup procedure.

The following message appears in the OSD.

6 Press

ENTER to start the setup

procedure.

This unit starts the auto setup procedure. Loud test

tones are output from each speaker during the auto

setup procedure. Once all items are set, the result

display appears in the OSD.

• During the auto setup procedure, do not perform any

operation on this unit.

• We recommend getting out of the room while this unit is in

the auto setup procedure. It takes approximately 3 minutes

for this unit to complete the auto setup procedure.

This unit performs the following checks:

Speaker wiring/volume level WIRING/LEVEL

Checks which speakers are connected and the

polarity of each speaker. Also checks and adjusts the

volume level of each speaker.

Speaker distance DISTANCE

Checks the distance of each speaker from the

listening position and adjusts the timing of each

channel.

Speaker size SIZE

Checks the frequency response of each speaker and

sets the appropriate low-frequency crossover for each

channel.

Note

Before proceeding next operation

Once you perform the next operation, this unit starts the

automatic setup procedure. For more accurate

measurements, keep quiet and move to the wall where

speakers are not around. We recommend that you leave

the listening room during the automatic setup

procedure.

NOTICE

output. 

Loudtesttonesare

 



Pleasekeepquiet

orleavetheroom.

Press[ENTER]

Notes

01EN_RX-V463_U.book Page 25 Friday, February 1, 2008 11:43 AM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 105 106

Comments to this Manuals

No comments

Yamaha RX-V463 Owner's Manual Page 29

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V463